Three-dimensional topographic effects on infrasound propagation across Ascension Island

Abstract

Summary Narrowband harmonic infrasound signals within the 1 to 8 Hz passband, generated by wind turbines on Ascension Island, have been recorded at four microbarometers located at distances of between 1.8 and 4.6 km from the source along different azimuths. Across one month of recordings in October 2010, amplitude ratios between the four recordings show temporal stability but deviate from the ratios expected for propagation across a flat plane. Using a recently developed three-dimensional parabolic equation method, that can incorporate realistic topography as a lower boundary, it is shown that these time-independent amplitude ratio deviations can be, in part, explained by acoustic interactions with topography that has scale lengths on the order of a few hundreds of metres. These interactions comprise both two-dimensional barrier effects that reduce sound levels behind high topography, and three-dimensional diffractive effects that increase sound levels behind topographic obstacles. For the Ascension Island case study, amplitudes along two of the four paths can be successfully modelled using a two-dimensional model, indicating that barrier effects dominate for these path geometries. Amplitude ratios along a third path, and the frequency-dependence of these ratios, are better simulated using a three-dimensional model that captures the out-of-plane diffractive effects around a prominent hill. The fourth path is poorly modelled using the three-dimensional model, which overpredicts acoustic amplitudes in this case. We hypothesise that this mismatch is likely to be due to a simplified description of the wind turbine source term. This study provides further observational confirmation that topographic interactions need to be considered when interpreting locally propagating infrasound, and shows that for harmonic narrowband sources a parabolic equation solver incorporating realistic boundary conditions provides an efficient method for simulating topographic interactions.

Yield Estimation of the August 2020 Beirut Explosion by Using Physics‐Based Propagation Simulations of Regional Infrasound

“…The inclusion of the stochastic weather models allows us to quantify the infrasound variability due to the weather uncertainty. We include 3‐D surface topography which can greatly impacts infrasound signal amplitudes (Khodr et al., 2022; Kim & Lees, 2011; Maher et al., 2021). Finally, we compare our infrasound‐based yield estimates with seismic analysis, exploring joint seismoacoustic constraint of yield.…”

“…Massive blast waves caused devastating damage to the urban area including more than 6,500 casualties (Nemer, 2021). This explosion was one of the largest single-fired AN explosions documented in history (Guglielmi, 2020). The explosion generated seismic waves equivalent to a M3.3-3.6 earthquake (Guglielmi, 2020) with infrasonic waves detected at distances up to 6,240 km (Pilger et al, 2021).…”

Remotely imaging seismic ground shaking via large-N infrasound beamforming

“…Although atmospheric models can be used to predict infrasound arrival patterns, unresolvable shorttime-scale atmospheric variability affects their accuracy 5 . Proximal infrasound, confined to the troposphere, experiences milder atmospheric path effects, but effects from topographic obstruction and diffraction can be noticeable 7 .…”