Turn hydrophobic to superhydrophobic of composite insulators by surface fluorination

Wang, F.; Wen, Gang; Feng, Feng; Zhang, T.; Li, J.

doi:10.1109/ichve.2016.7800815

Cited by 5 publications

(1 citation statement)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Scanning Electron Microscopy (SEM) was conducted after DC incline plane test was done. The SEM conducted to make analysis of surface morphology of the insulator housing can be effectively used as a tool for the measurement of extent of degradation during aging [13,14]. Beside the condition of the surface on insulator were tested.…”

Section: Results From DC Incline Plane Test (Ipt)mentioning

confidence: 99%

DC inline plane test of silicone rubber samples with different filler for high-voltage insulation

Norddin

Saadon

Kamarudin

et al. 2020

IJEECS

View full text Add to dashboard Cite

<span>This paper is about preparation of silicone rubber (SiR) samples with different filler for high-voltage insulation purpose. The fillers used were silica from waste glass, calcium carbonate from cockle shell, silica/calcium carbonate and wollastonite. All the fillers were crushed into powder and undergo internal mixer and hot press as a material preparation. It was expected that the combination of filler with silicone rubber would give better result when experiencing ageing process. The direct current (DC) inclined plane test was used to investigate the tracking and erosion on silicone rubber composites. The tracking length was observed between the top and bottom electrode. Comparison would then be made between the silicone rubbers with different fillers based on the result obtained from the experiment.</span>

show abstract

Section: Results From DC Incline Plane Test (Ipt)mentioning

confidence: 99%