Understanding the effect of Intake temperature on the ϕ-sensitivity of toluene-ethanol reference fuels and neat ethanol

Abstract

The low-temperature combustion (LTC) is an attractive concept that enables the modem combustion engines to move toward sustainability mainly by increasing the efficiency and decreasing the emissions. The modern combustion engines which are working based on the LTC concept have specific fuel requirements. Fuel ϕ-sensitivity is a key factor to be considered for tailoring fuels for these engines. Fuel with a high ϕ-sensitivity are more responsive to thermal or fuel stratifications; the auto-ignition properties of different air-fuel mixtures of these fuels, with different equivalence ratio (ϕ), are more diverse. This diversity provide a smoother heat release rate in stratified condition. In this study 11 different toluene–ethanol reference fuels (TERFs) in three research octane number (RON) groups of 63, 84, and 105 together with neat ethanol are evaluated. The Lund ϕ-sensitivity method is used to evaluate these fuels in a cooperative fuel research (CFR) engine. The effect of variation of intake temperature on pressure sensitivity of fuel at a constant combustion phasing is evaluated. This evaluation is performed at two intake temperature of 373 and 423 K, and the results are compared with the outcome of the Lund ϕ-sensitivity number with the intake temperature of 323 K. This study shows that the CR sensitivity response of different blends to the intake charge temperature variation depends on the fuel composition. Accumulated low temperature heat release and latent heat of vaporization. It proves that the fuel ϕ-sensitivity will vary under different thermodynamic conditions. There was a clear link between the accumulated heat released during the early reaction and CR sensitivity of the blends at different intake temperature of 373 and 423 K but the link with the latent heat of vaporization (HoV) found to be inexplicit.

Fuel-air mixing in motored CFR engine at research octane number (RON) relevant condition

“…The use of CFR engine for experimental determination of combustion characteristics is common in literature. [8][9][10][11] However, the numerical simulation of CFR engine is sparse. Recently, Garcı´a et al 12 have developed a virtual 1-D model of CFR engine with GT Power.…”