Upscaling of elastic properties for large scale geomechanical simulations

Abstract

SUMMARYLarge scale geomechanical simulations are being increasingly used to model the compaction of stress dependent reservoirs, predict the long term integrity of under-ground radioactive waste disposals, and analyse the viability of hot-dry rock geothermal sites. These large scale simulations require the definition of homogenous mechanical properties for each geomechanical cell whereas the rock properties are expected to vary at a smaller scale. Therefore, this paper proposes a new methodology that makes possible to define the equivalent mechanical properties of the geomechanical cells using the fine scale information given in the geological model. This methodology is implemented on a synthetic reservoir case and two upscaling procedures providing the effective elastic properties of the Hooke's law are tested. The first upscaling procedure is an analytical method for perfectly stratified rock mass, whereas the second procedure computes lower and upper bounds of the equivalent properties with no assumption on the small scale heterogeneity distribution. Both procedures are applied to one geomechanical cell extracted from the reservoir structure. The results show that the analytical and numerical upscaling procedures provide accurate estimations of the effective parameters. Furthermore, a large scale simulation using the homogenized properties of each geomechanical cell calculated with the analytical method demonstrates that the overall behaviour of the reservoir structure is well reproduced for two different loading cases.

Fiber Optic Sensing for Geomechanical Monitoring: (2)- Distributed Strain Measurements at a Pumping Test and Geomechanical Modeling of Deformation of Reservoir Rocks

“…Generally geological materials contain inhomogeneous structures over a wide scale range from the scale of grains and pores to that of reservoirs; the scaling up of permeability and elastic modulus is commonly required in reservoir simulations and rock mechanics. Numerical simulations are widely conducted to obtain the scaled-up elastic stiffness tensors [40,41] and permeability [42]. The scaled-up parameters are expected to be equivalent to the elastic stiffness tensors that include the fine-scale contribution to coarsen the geomechanical mesh.…”

A True Poroelastic Up and Downscaling Scheme for Multi-scale Coupled Simulation

“…To address this issue, one can resort to multi-scale modeling (e.g. Chalon et al 2004;Zhang and Fu 2010).…”