Useful features of automated test systems in the R&amp;D laboratory

Czapski, J.

doi:10.1109/autest.2000.885647

Cited by 2 publications

(1 citation statement)

References 17 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…2000 rpm then if 5V is applied to servo drive then it drives the motor at 1000 rpm). Figure 1 shows the block diagram of system and it depicts an in-expensive PC based Automated Test System (ATS) [8] design.…”

Section: Overview Of the Systemmentioning

confidence: 99%

LabVIEW FPGA based Software Implementation for an Automated Test System of Shafts used in High Lift System of an Aircraft

C.¹,

Karanth²,

Karthik³

et al. 2012

IJCA

View full text Add to dashboard Cite

Shafts used in the high lift system (wings of a plane) of an aircraft undergo extreme load conditions during takeoff and landing. Performance of shaft deteriorates along the life span of it. The failure of shaft can lead to a major catastrophe. Therefore, to ensure the safety of passengers, there is a need to develop a test system which can subject different shafts to various loads to which they are designed for and test them for their life cycle. This paper presents implementation of a test system built using LabVIEW -Field Programmable Gate Array (FPGA) which is able to simulate different load conditions on shaft. The real time data of torque and speed values are recorded using FPGA card. Software design of test system and results obtained for a test shaft are discussed in this paper. General TermsAutomated Test System, LabVIEW FPGA.

show abstract

Section: Overview Of the Systemmentioning

confidence: 99%

LabVIEW FPGA based Software Implementation for an Automated Test System of Shafts used in High Lift System of an Aircraft

C.¹,

Karanth²,

Karthik³

et al. 2012

IJCA

View full text Add to dashboard Cite

show abstract

Automated Testing System for a CAN Communication Circuit

Prutianu¹,

Popescu²,

Lascu³

2012

AECE

View full text Add to dashboard Cite

The paper presents a method for validation/testing a control area network (CAN) communication circuit used in all electronic control units (ECUs) developed in automotive industry after 2000. Using a specific hardware configuration and remotely controlled by LabVIEW. The author's presents their own vision regarding operational software algorithm implementation and integration / execution of some test cases in order to validate a CAN circuit. Using this method, it is possible to validate/test CAN hardware circuits in a short time and with the possibility of saving the test results. Human operator is interfering with the system only through the graphical user interface. The error sources for this system are reduced to minimum

show abstract

Useful features of automated test systems in the R&D laboratory

Cited by 2 publications

References 17 publications

LabVIEW FPGA based Software Implementation for an Automated Test System of Shafts used in High Lift System of an Aircraft

LabVIEW FPGA based Software Implementation for an Automated Test System of Shafts used in High Lift System of an Aircraft

Automated Testing System for a CAN Communication Circuit

Contact Info

Product

Resources

About