UV-Matrix-assisted laser desorption/ionization time-of-flight mass spectrometry analysis of synthetic polymers by using nor-harmane as matrix

Three xylan fractions isolated from the red seaweed Nothogenia fastigiata (Nemaliales) were analyzed by ultraviolet matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (UV-MALDI-TOFMS). UV-MALDI-TOFMS was carried out in the linear and reflectron modes, and as routine in the positive and negative ion modes. Of the several matrices tested, nor-harmane was the only effective one giving good spectra in the positive ion mode. The number-average molar masses of two of the fractions, calculated from the distribution profiles, were lower than those determined previously by (1)H NMR analysis, suggesting a decrease in the ionization efficiency with increasing molecular weight; weight-average molar mass and polydispersity index were also determined. As the xylans retained small but significant quantities of calcium salts, the influence of added Ca(2+) as CaCl(2) on UV-MALDI-MS was investigated. The simultaneous addition of sodium chloride and calcium chloride was also analyzed. Addition of sodium chloride did not change the distribution profile of the native sample showing that the inhibitory effect is due to Ca(2+) and not to Cl(-). Addition of calcium chloride with 1:1 analyte/salt molar ratio gave spectra with less efficient desorption/ionization of oligomers; the signals of these oligomers were completely suppressed when the addition of the salt became massive (1:100 analyte/salt molar ratio).

show abstract

Using solvent‐free sample preparation to promote protonation of poly(ethylene oxide)s with labile end‐groups in matrix‐assisted laser desorption/ionisation

Mazarin

Phan

Charles

2008

Rapid Comm Mass Spectrometry

View full text Add to dashboard Cite

Protonation is usually required to observe intact ions during matrix-assisted laser desorption/ionization (MALDI) of polymers containing fragile end-groups while cation adduction induces chain-end degradation. These polymers, generally obtained via living free radical polymerization techniques, are terminated with a functionality in which a bond is prone to homolytic cleavage, as required by the polymerization process. A solvent-free sample preparation method was used here to avoid salt contaminant from the solvent traditionally used in the dried-droplet MALDI procedure. Solvent-based and solvent-free sample preparations were compared for a series of three poly(ethylene oxide) polymers functionalized with a labile end-group in a nitroxide-mediated polymerization reaction, using 2,4,6-trihydroxyacetophenone (THAP) as the matrix without any added salt. Intact oligomer ions could only be produced as protonated molecules in solvent-free MALDI while sodium adducts of degraded polymers were formed from the dried-droplet samples. Although MALDI analysis was performed at the laser threshold, fragmentation of protonated macromolecules was still observed to occur. However, in contrast to sodiated molecules, dissociation of protonated oligomers does not involve the labile C--ON bond of the end-group. As the macromolecule size increased, protonation appeared to be less efficient and sodium adduction became the dominant ionization process, although no sodium salt was added in the preparation. Formation of sodiated degraded macromolecules would be dictated by increasing cation affinity as the size of the oligomers increases and would reveal the presence of salts at trace levels in the MALDI samples.

show abstract

UV-Matrix-assisted laser desorption/ionization time-of-flight mass spectrometry analysis of synthetic polymers by using nor-harmane as matrix

Cited by 12 publications

References 31 publications

The Development of Matrix‐Assisted Laser Desorption/Ionization Sources

The Development of Matrix‐Assisted Laser Desorption/Ionization Sources

Matrix‐assisted ultraviolet laser desorption/ionization time‐of‐flight mass spectrometry of β‐(1 → 3), β‐(1 → 4)‐xylans from Nothogenia fastigiata using nor‐harmane as matrix

Using solvent‐free sample preparation to promote protonation of poly(ethylene oxide)s with labile end‐groups in matrix‐assisted laser desorption/ionisation

Contact Info

Product

Resources

About