Vapor–liquid equilibria of systems containing acetic acid and gaseous components. Measurements and calculations by a cubic equation of state

Jonasson, Ari; Persson, Ole; Rasmussen, Peter; Soave, Giorgio

doi:10.1016/s0378-3812(98)00397-5

Cited by 32 publications

(20 citation statements)

References 21 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In our data collection, an electronic database, i.e., EVLM92 has been referenced, which contains the citation of the experimental data from the year of 1888 until 2004. The Korean database93 and DECHEMA94 series as well as literature data70, 76, 95–139 were referenced.…”

Section: Resultsmentioning

confidence: 99%

Transferable intermolecular potentials for carboxylic acids and their phase behavior

Vahid

Elliott

2009

AIChE Journal

View full text Add to dashboard Cite

in Wiley InterScience (www.interscience.wiley.com).Transferable step potentials are characterized for 39 carboxylic acids. The reference potential is treated with discontinuous molecular dynamics, including detailed molecular structure. Thermodynamic perturbation theory is used to interpret the simulation results and to provide an efficient basis for molecular modeling and characterization of the attractive forces. Four steps are used for representation of the attractive forces with only the first and last steps varied independently. The two middle steps are interpolated such that each site type is characterized by three parameters: the diameter, r, the depth of the inner well, e 1 , and the depth of the outer well, e 4 . The depths of the attractive wells are optimized to fit experimental vapor pressure and liquid density data. Generally, the vapor pressure is correlated to an overall 43% average absolute deviation (% AAD) and the liquid density to 5% AAD. The deviations tend to be largest for the higher molecular weight acids. These deviations are larger than the errors previously encountered in characterizing organic compounds, but carboxylic acids present exceptional challenges owing to their peculiar dimerization behavior. Simultaneous correlation of vapor pressure, vapor compressibility factor, and phase equilibria of water þ carboxylic acids place several constraints on the nature of the potential model, with the parameters of the present model representing a reasonable tradeoff. In other words, our model represents minimal deviations for vapor pressure, vapor compressibility factor, and phase equilibria of all acids simultaneously while varying the parameters r, e 1 , e 4 , e CC (dimerizing site bonding energy), e AD (acceptor-donor bonding energy), and K HB (hydrogen bonding volume) for the acid O¼ ¼ and OH site types. The present model is characterized by one acceptor and one dimerizing site on the carbonyl oxygen and one acceptor and one donor site on the hydroxyl oxygen. The acceptor and donor are capable of interacting with water while the dimerizing site is not. With this model, the saturated vapor compressibility factor of acids with seven or fewer carbons is near 0.5 while higher carbon ratios lead to a compressibility factor approaching 1.0. To compensate for the high vapor pressure deviations of the transferable potential model, a correction is introduced to customize the molecule-molecule self interaction energy. This adaptation results in deviations of 3.1% for vapor pressure of the pure acid database. To validate the behavior of the model for carboxylic acids in mixtures, 33 binary solutions were considered. Acids in this database ranged from formic to hexadecanoic. The average absolute deviation in bubble pressure for Additional Supporting Information may be found in the online version of this article.Correspondence concerning this article should be addressed to J. R. Elliott at dickelliott@uakron.edu aqueous acid systems is 4.4%, 10.5% for acid þ acid systems, and 4.7% for acid þ n-alkane s...

show abstract

Section: Resultsmentioning

confidence: 99%

Transferable intermolecular potentials for carboxylic acids and their phase behavior

Vahid

Elliott

2009

AIChE Journal

View full text Add to dashboard Cite

show abstract

Section: Resultsmentioning

confidence: 99%

Effect of different isocyanates on the properties of soy‐based polyurethanes

Javni¹,

Zhang²,

Petrovìć³

2003

J of Applied Polymer Sci

152

127

View full text Add to dashboard Cite

New types of polyurethanes were prepared by reacting soybean oil-based polyol and different isocyanates. The polyurethanes can be used as foams, elastomers, coatings, adhesives, etc. Their properties strongly depend on crosslinking density and the structure of isocyanates. Aromatic triisocyanates impart the highest density, glass transition, modulus, and tensile strength, but have the lowest elongation at break, swelling in toluene, and impact resistance. Aliphatic triisocyanates and diisocyanates give rubbery materials with the highest elongation at break, highest swelling, and the lowest tensile strength. Polyurethanes with aromatic and cycloaliphatic diisocyanates were similar in properties, with values between those of the two groups.

show abstract

“…Carboxylic acids can form dimers in the vapor phase as well as dimers, trimers or even oligomers in the liquid phase. Several previous works with the CPA EoS or with some variants of the SAFT EoS had already discussed the best association scheme for organic acids 16–20. Several association schemes were evaluated for both the gas and liquid phases (1A, 2B, and 4C).…”

Section: Methodsmentioning

confidence: 99%

“…The coupling of a cubic equation of state (SRK) with a model that expresses the dimerization of the acid molecules was also used to correlate experimental VLE for gases in acetic acid 16, 17…”

Section: Introductionmentioning

confidence: 99%

Description of the mutual solubilities of fatty acids and water with the CPA EoS

et al. 2009

View full text Add to dashboard Cite

in Wiley InterScience (www.interscience.wiley.com).Data for the mutual solubilities of fatty acid þ water mixtures are scarce and so measurements for seven fatty acid (C 5 -C 10 , C 12 ) þ water systems were carried out. This new experimental data was successfully modelled with the cubic plus association EoS. Using data from C 6 to C 10 and the Elliot's cross-associating combining rule a correlation for the k ij binary interaction parameter, as a function of the acid chain length, is proposed. The mutual solubilities of water and fatty acids can be adequately described with average deviations inferior to 6% for the water rich phase and 30% for the acid rich phase. Furthermore, satisfactory predictions of solid-liquid equilibria of seven fatty acids (C 12 -C 18 ) þ water systems were achieved based only on the k ij correlation obtained from liquid-liquid equilibria data.

show abstract

Vapor–liquid equilibria of systems containing acetic acid and gaseous components. Measurements and calculations by a cubic equation of state

Cited by 32 publications

References 21 publications

Transferable intermolecular potentials for carboxylic acids and their phase behavior

Transferable intermolecular potentials for carboxylic acids and their phase behavior

Effect of different isocyanates on the properties of soy‐based polyurethanes

Description of the mutual solubilities of fatty acids and water with the CPA EoS

Contact Info

Product

Resources

About