In this paper, we study the impact of the idle/dynamic power consumption ratio on the effectiveness of a multi-V dd /frequency manycore design. We propose a new tool called LVSiM (a Low-Power and Variation-Aware Manycore Simulator) to carry out the experiments. It is a novel manycore simulator targeted towards low-power optimization methods including within-die process and workload variations. LVSiM provides a holistic platform for multi-V dd /frequency voltage island analysis, optimization, and design. It provides a tool for the early design exploration stage to analyze large-scale manycores with a given number of cores on 3D-stacked layers, network-on-chip communication busses, technology parameters, voltage and frequency values, and power grid parameters, using a variety of different optimization methods. LVSiM has been calibrated with Sniper/McPAT at a nominal frequency, and then the energy-delay-product (EDP) numbers were compared after frequency scaling. The average error is shown to be 10% after frequency scaling, which is sufficient for our purposes. The experiments in this work are carried out for different Idle/Dynamic ratios considering 1260 benchmarks with task sizes ranging from 4000 to 16 000 executing on 3200 cores. The best configurations are shown to produce on average 20.7% to 24.6% EDP savings compared to the nominal configuration. Traditional scheduling methods are used in the nominal configuration with the unused cores switched off. In addition, we show that, as the Idle/Dynamic ratio increases, the multi-V dd /frequency approach becomes less effective. In the case of a high Idle/Dynamic ratio, the minimum EDP can be achieved through switching off unused cores as opposed to using a multi-V dd /frequency approach. This conclusion is important, especially in the dark-silicon era, where switching cores on and/or off as needed is a common practice.