Voltage stability assessment accounting for non‐linearity of Thévenin voltages

Karatas, Bahtiyar Can; Jóhannsson, Hjörtur; Nielsen, Arne Hejde

doi:10.1049/iet-gtd.2019.1774

Cited by 3 publications

(1 citation statement)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The effect of load active and reactive power change on the power system's TI is discussed in [2]. Few works are dealing with the power system impedance evaluation for purposes of voltage stability analysis using different techniques [3][4][5][6]. Analysis of the influence of wind power station on the power system's Thevenin equivalent impedance is discussed in [7].…”

Section: Introductionmentioning

confidence: 99%

Power System Impedance Estimation Using a Fast Voltage and Current Changes Measurements

et al. 2020

View full text Add to dashboard Cite

Equivalent power system impedance is an important electrical quantity from many points of view. Areas in which this parameter plays an important role include, in particular: Voltage stability analysis, power quality, or fault condition analysis. Power system impedance estimation in real operation conditions can be performed by one of the non-invasive methods described by different authors. This paper aims to investigate and compare seven different methods for power system impedance estimation based on voltage and current variations measurement. After a brief description of selected methods, these methods were applied for power system impedance estimation in the case of two simple simulation tests and then in the case of three real measured data. Voltage and current changes used for power system impedance estimation in real conditions were measured in high voltage (HV) and medium voltage (MV) substations feeding steel mill with the electric arc furnace (EAF) operation. As the results presented in this paper have shown, not all of the methods analyzed are suitable for determining the power system impedance based on the fast step changes of voltage and current that occur, for example, during an EAF operation. Indeed, some of the tested methods were originally designed to determine the power system impedance from changes in voltages and currents recorded at steady state.

show abstract