Waste-Heat Recovery in Batch Processs Using Heat Storage

Abstract

The waste-heat recovery in batch processes has been studied using the pinch-point method. The aim of the work has been to investigate theoretical and practical approaches to the design of heat-exchanger networks, including heat storage, for waste-heat recovery in batch processes. The study is limited to the incorporation of energy-storage systems based on fixed-temperature variable-mass stores. The background for preferring this to the alternatives (variable-temperature fixed-mass and constant-mass constant-temperature (latent-heat) stores) is given. It is shown that the maximum energy-saving targets as calculated by the pinch-point method (time average model, TAM) can be achieved by locating energy stores at either end of each process stream. This theoretically large number of heat-storage tanks (twice the number of process streams) can be reduced to just a few tanks. A simple procedure for determining a number of heat-storage tanks sufficient to achieve the maximum energy-saving targets as calculated by the pinch-point method is described. This procedure relies on combinatorial considerations, and could therefore be labeled the “combinatorial method” for incorporation of heat storage in heat-exchanger networks. Qualitative arguments justifying the procedure are presented. For simple systems, waste-heat recovery systems with only three heat-storage temperatures (a hot storage, a cold storage, and a heat store at the pinch temperature) often can achieve the maximum energy-saving targets. Through case studies, six of which are presented, it is found that a theoretically large number of heat-storage tanks (twice the number of process streams) can be reduced to just a few tanks. The description of these six cases is intended to be sufficiently detailed to serve as benchmark cases for development of alternative methods.

Heat integration of intermittently available continuous streams in multipurpose batch plants

“…Clayton (1988) determined the energy reduction potential using the time average model (TAM), assuming that the hot and cold streams exist simultaneously as in continuous processes. Stolze et al (1995) addressed this unrealistic assumption by incorporating…”

A solid thermal storage model for the optimization of buildings operation strategy

“…Researchers have paid much attention in the literature on thermo-economic simulations and synthesis of a thermal storage unit in batch processes. Stoltze et al [1] studied the integration of heat storage units for waste-heat recovery. They proposed the "combinatorial method" for an incorporation of heat storage tanks in batch processes.…”

Thermal Energy Storage Integration Based on Pinch Analysis – Methodology and Application

“…As a result, the software tools that support this type of analysis have been tailored to continuous processes to optimize them for direct heat recovery (DHR), often neglecting the needs for batch or semicontinuous processes. However, some estimates are as high as 50 % for the share of batch processes of all industrial processes worldwide . Even though such processes exhibit time‐dependent behavior that can include inherent variability in the heating and cooling demands, a significant potential for thermal efficiency improvement exists.…”