Abstract-In this paper, a loading technique for improving pulse radiation from bow-tie antennas is introduced. This technique allows transmission of short transient pulses with very small latetime ringing and relatively high radiation efficiency. It makes use of a combination of a constant resistive loading along the antenna and a capacitive loading with linearly increasing reactance toward the antenna ends. The constant resistive loading is applied using volumetric microwave absorbers to cover one side of the antenna and the linear capacitive loading is realized by constructing narrow slots on the antenna surface. Relatively high radiation efficiency is achieved by choosing the location of the slot nearest to the feed point in such a way that radiation from it combines constructively with radiation from the feed point. Using a 0.8-ns monocycle for excitation, the technique results in a level of late-time ringing of lower than 40 dB and at the same time the peak value of the transmitted pulse is 54% higher than that of the same antenna without loading.Index Terms-Bow-tie antennas, capacitive loading, resistive loading, ultrawide-band antennas.

No abstract

The analysis, design, and realization of a modified bow-tie antenna optimized for impulse ground penetrating radar (GPR) applications is described. The proposed antenna shows improved properties important for GPR, which include its compact size (in comparison with a conventional bow-tie antenna) and ability to radiate UWB pulses with increased amplitude and very small late-time ringing. A substantial increase in the amplitude of the transmitted pulse is achieved by utilizing radiation from discontinuities introduced by the resistive loading employed in the antenna to suppress late-time ringing. By choosing an optimal distance between the antenna's feed point and the location of the resistive loading, radiations that occur from the antenna's feed point and the mentioned discontinuities at the resistive loading will combine constructively in the boreside direction of the antenna. As a result, one will observe a substantial increase of the amplitude of the transmitted pulse in the boreside direction. Furthermore, an analytical expression describing approximate time-harmonic current distribution is derived to indicate an optimal resistive loading profile for the proposed antenna. Additionally, the traveling-wave current distribution of the antenna is theoretically analyzed to examine the applicability of the obtained time-harmonic expression for pulse excitation. It has been found that when the antenna is resistively loaded both the time-harmonic and traveling-wave currents decay to approach nearly the same value at the end section of the antenna. As the amount of current at the antenna ends corresponds to the level of reflection which occurs there, the derived expression is found to be useful to indicate an optimal loading profile for the proposed antenna. A theoretical model of the proposed antenna has been developed to perform numerical analysis using a modified NEC-2 code. In addition, an experimental verification has been carried out and both the simulation and experiment confirmed the improved properties of the proposed antenna.