This paper examines the effect of dispersant and anti-wear additives on fretting wear in lubricated bearing steel contacts. Reciprocating sliding ball-on-flat fretting tests with a stroke length of 50 μm have been carried out on steel-to-steel contacts in both dry and lubricated conditions. Wear and friction coefficient have been measured, and surface characterisation has been carried out using optical techniques to investigate fretting wear. The presence of base oil reduces fretting wear markedly compared to dry conditions, but fretting damage is still observed at low reciprocation frequencies. As frequency is increased, there is a transition from oxidative to adhesive/scuffing damage. The anti-wear additive ZDDP is effective in forming a tribofilm on the surfaces and reducing visible oxidation and wear. A succinimide dispersant also reduces the accumulation of solid debris but does not alleviate wear damage. The combination of both ZDDP anti-wear additive and dispersant in base oil appears to provide significant protection against fretting wear.

Due to incomplete combustion, high levels of soot can accumulate in engine lubricants between drain intervals. This soot can promote wear of engine parts such as timing chains and cam followers. One standard approach to reducing wear is to increase the hardness of the rubbing components used. According to the Archard wear equation, wear rate should be broadly inversely proportional to hardness. To explore this approach for controlling soot wear, wear tests have been conducted in a High Frequency Reciprocating Rig (HFRR) with HFRR steel discs of various hardness against a hard steel ball. Carbon black (soot surrogate) dispersions in model lubricants based on solutions of ZDDP and dispersant in GTL base oils have been studied. Wear volumes have been measured and wear scars and tribofilms analysed using scanning white light interferometry and SEM-EDS. It is found that, while most oils show wear that reduces with increasing hardness, for blends that contain both ZDDP and carbon black, wear rate markedly increases with disc hardness as the latter approaches the hardness of the ball. The results support the prevalence of a corrosive-abrasive wear mechanism when carbon black and ZDDP are both present in a lubricant and suggests that selection of very hard surfaces may not be a useful way to control soot

Diesel engines and gasoline direct injection (GDI) engines both produce soot due to incomplete combustion of the fuel and some enters the lubricant where it accumulates between drain intervals, promoting wear of rubbing engine components. Currently the most favoured mechanism for this wear is that the anti-wear additives present in engine oils, primarily zinc dialkyldithiophosphates (ZDDPs), react very rapidly with rubbing surfaces to form relatively soft reaction products. These are easily abraded by soot, resulting in a corrosive-abrasive wear mechanism. This study has explored the impact of engine oil dispersant additives on this type of wear using combinations of dispersant, ZDDP and carbon black, a soot surrogate. It has been found that both the concentration and type of dispersant are critical in influencing wear. With most dispersants studied, wear becomes very high over an intermediate dispersant concentration range of ca 0.1-0.4 wt% N, with both lower and higher dispersant levels showing much less wear. However a few dispersants appear able to suppress high wear by ZDDP and carbon black over the whole concentration range. A series of experiments have been carried out to determine the origin of this behaviour and it is believed that high levels of dispersant, and, for a few dispersants, all concentration levels, protect the iron sulphide tribofilm initially formed by ZDDP from abrasion by carbon black.

No abstract