The impact of emissions from the fuel and energy sectors adversely affects the environment on the economies of countries. One of these pollutants is volatile organic compounds (VOCs), which contribute to the formation of tropospheric ozone. Emissions of hydrocarbon formation in the form of VOCs occur in four stages of the fuel and energy industry sector: (1) production, (2) processing, (3) transportation, and (4) storage. The oil and gas industry ranks among the top polluting industries in terms of VOC emissions. Research on the negative impact of VOCs, as well as CO2 emissions from the consequences of the extraction, processing, transport, and storage of oil and gas on the ecosystem of the planet and the population, has begun to be studied by science recently. Typically, these studies were conducted using laboratory and field analyses, as well as using data on anthropogenic emissions in the development of regulatory documents and requirements governing the control of VOC and CO2 emissions in the oil and gas industry. This paper presents a critical analysis of the literature on research on the negative effects of VOC emissions on the ecosystem and human health because of such factors as production, processing, transportation, and storage of hydrocarbons. This analysis shows the global magnitude of VOC emissions. Data from human‐made emissions from the oil and gas industry and direct emissions from transportation and energy processing were used to figure out how VOCs affect the environment around the world and how far they spread. In conclusion, this study found patterns of VOC emissions that show how important it is to control VOCs during the production, processing, transportation, and storage of oil and gas, as well as how important it is to create a single research base on emissions for each industry sector and on sources of greenhouse gas absorption.

This study determines and presents the capital and operating costs imposed by the use of CO2 capture technologies in the refining and petrochemical sectors. Depending on the refining process and the CO2 capture method, CO2 emissions costs of EUR 30 to 40 per ton of CO2 can be avoided. Advanced low-temperature CO2 capture technologies for upgrading oxyfuel reformers may not provide any significant long-term and short-term benefits compared to conventional technologies. For this reason, an analysis was performed to estimate the CO2 reduction potential for the oil and gas industries using short- and long-term ST/MT technologies, was arriving at a reduction potential of about 0.5–1 Gt/yr. The low cost of CO2 reduction is a result of the good integration of CO2 capture into the oil production process. The results show that advanced gasoline fraction recovery with integrated CO2 capture can reduce the cost of producing petroleum products and reduce CO2 emissions, while partial CO2 capture has comparative advantages in some cases.

In recent years, significant efforts have been made to accelerate the economic development of the Arctic zone, leading to intense environmental pollution of this region, accompanied by the significant impact of accumulated environmental damage in the region. The solution to these problems is difficult due to the remoteness of these areas and severe climatic conditions. Therefore, it is important to evaluate the potential for restoration of arctic soils. For this purpose, various indicators are used, including biological ones. In the analyzed arctic soil samples, high concentrations of petroleum hydrocarbons (up to 47,000 mg/kg) and chloride-ions (0.10–0.14 wt %) were established. Microbioassay demonstrated a presence of hydrocarbon-oxidizing microorganisms: Penicillium, Azotobacter chroococcum, Bacillus subtilis, Pseudomonas oleovorans. A low enzymatic activity and specific Arctic climate point out a low self-restoration ability of the soil, demonstrated the need for its remediation. The microbioassay with microbial strains identification and soil remediation methods suitable for the Arctic zone were recommended.

No abstract