New regulatory and consumer demands highlight the importance of animal feed as a part of our national food safety system. Porcine epidemic diarrhea virus (PEDV) is the first viral pathogen confirmed to be widely transmissible in animal food. Because the potential for viral contamination in animal food is not well characterized, the objectives of this study were to 1) observe the magnitude of virus contamination in an animal food manufacturing facility, and 2) investigate a proposed method, feed sequencing, to decrease virus decontamination on animal food-contact surfaces. A U.S. virulent PEDV isolate was used to inoculate 50 kg swine feed, which was mixed, conveyed, and discharged into bags using pilot-scale feed manufacturing equipment. Surfaces were swabbed and analyzed for the presence of PEDV RNA by quantitative real-time polymerase chain reaction (qPCR). Environmental swabs indicated complete contamination of animal food-contact surfaces (0/40 vs. 48/48, positive baseline samples/total baseline samples, positive subsequent samples/total subsequent samples, respectively; P < 0.05) and near complete contamination of non-animal food-contact surfaces (0/24 vs. 16/18, positive baseline samples/total baseline samples, positive subsequent samples/total subsequent samples, respectively; P < 0.05). Flushing animal food-contact surfaces with low-risk feed is commonly used to reduce cross-contamination in animal feed manufacturing. Thus, four subsequent 50 kg batches of virus-free swine feed were manufactured using the same system to test its impact on decontaminating animal food-contact surfaces. Even after 4 subsequent sequences, animal food-contact surfaces retained viral RNA (28/33 positive samples/total samples), with conveying system being more contaminated than the mixer. A bioassay to test infectivity of dust from animal food-contact surfaces failed to produce infectivity. This study demonstrates the potential widespread viral contamination of surfaces in an animal food manufacturing facility and the difficulty of removing contamination using conventional feed sequencing, which underscores the importance for preventing viruses from entering and contaminating such facilities.

Porcine Epidemic Diarrhea Virus (PEDV) was the first virus of wide scale concern to be linked to possible transmission by livestock feed or ingredients. Measures to exclude pathogens, prevent cross-contamination, and actively reduce the pathogenic load of feed and ingredients are being developed. However, research thus far has focused on the role of chemicals or thermal treatment to reduce the RNA in the actual feedstuffs, and has not addressed potential residual contamination within the manufacturing facility that may lead to continuous contamination of finished feeds. The purpose of this experiment was to evaluate the use of a standardized protocol to sanitize an animal feed manufacturing facility contaminated with PEDV. Environmental swabs were collected throughout the facility during the manufacturing of a swine diet inoculated with PEDV. To monitor facility contamination of the virus, swabs were collected at: 1) baseline prior to inoculation, 2) after production of the inoculated feed, 3) after application of a quaternary ammonium-glutaraldehyde blend cleaner, 4) after application of a sodium hypochlorite sanitizing solution, and 5) after facility heat-up to 60°C for 48 hours. Decontamination step, surface, type, zone and their interactions were all found to impact the quantity of detectable PEDV RNA (P < 0.05). As expected, all samples collected from equipment surfaces contained PEDV RNA after production of the contaminated feed. Additionally, the majority of samples collected from non-direct feed contact surfaces were also positive for PEDV RNA after the production of the contaminated feed, emphasizing the potential role dust plays in cross-contamination of pathogen throughout a manufacturing facility. Application of the cleaner, sanitizer, and heat were effective at reducing PEDV genomic material (P < 0.05), but did not completely eliminate it.

Porcine epidemic diarrhea virus (PEDV) is a heat-sensitive virus that has devastated the U.S. swine industry. Because of its heat sensitivity, we hypothesized that a steam conditioner and pellet mill mimicking traditional commercial thermal processing may mitigate PEDV infectivity. Pelleting, a common feed processing method, includes the use of steam and shear forces, resulting in increased temperature of the processed feed. Two thermal processing experiments were designed to determine if different pellet mill conditioner retention times and temperatures would impact PEDV quantity and infectivity by analysis of quantitative reverse transcription PCR and bioassay. In Exp. 1, a 3 × 3 × 2 factorial design was used with 3 pelleting temperatures (68.3, 79.4, and 90.6°C), 3 conditioning times (45, 90, or 180 s), and 2 doses of viral inoculation (low, 1 × 10 tissue culture infectious dose (the concentration used to see cytopathic effect in 50% of the cells)/g, or high, 1 × 10 tissue culture infectious dose/g). Noninoculated and PEDV-inoculated unprocessed mash were used as controls. The low-dose PEDV-infected mash had 6.8 ± 1.8 cycle threshold (Ct) greater ( < 0.05) PEDV than the high-dose mash. Regardless of time or temperature, pelleting reduced ( < 0.05) the quantity of detectable viral PEDV RNA compared with the PEDV-inoculated unprocessed mash. Fecal swabs from pigs inoculated with the PEDV-positive unprocessed mash, regardless of dose, were clinically PEDV positive from 2 to 7 d (end of the trial) after inoculation. However, if either PEDV dose of inoculated feed was pelleted at any of the 9 tested conditioning time × temperature combinations, no PEDV RNA was detected in fecal swabs or cecum content. Based on Exp. 1 results, a second experiment was developed to determine the impact of lower processing temperatures on PEDV quantity and infectivity. In Exp. 2, PEDV-inoculated feed was pelleted at 1 of 5 conditioning temperatures (37.8, 46.1, 54.4, 62.8, and 71.1°C) for 30 s. The 5 increasing processing temperatures led to feed with respective mean Ct values of 32.5, 34.6, 37.0, 36.5, and 36.7, respectively. All samples had detectable PEDV RNA. However, infectivity was detected by bioassay only in pigs from the 37.8 and 46.1°C conditioning temperatures. Experiment 2 results suggest conditioning and pelleting temperatures above 54.4°C could be effective in reducing the quantity and infectivity of PEDV in swine feed. However, additional research is needed to prevent subsequent recontamination after pelleting as it is a point-in-time mitigation step.

Due to recent large outbreaks, peanuts have been considered a product of potential risk for Salmonella. Usually, peanut products show a low water activity (a w) and high fat content, which contribute to increasing the thermal resistance and survival of Salmonella. This study evaluated the long-term kinetics of Salmonella survival on different peanut products under storage at 28˚C for 420 days. Samples of raw in-shell peanuts (a w = 0.29), roasted peanuts (a w = 0.39), unblanched peanut kernel (a w = 0.54), peanut brittle (a w = 0.30), paçoca (a w = 0.40) and pé-de-moça (a w = 0.68) were inoculated with Salmonella Typhimurium ATCC 14028 at two inoculum levels (3 and 6 log cfu/ g). The Salmonella behavior was influenced (p<0.05) by a w , lipid, carbohydrate and protein content. In most cases for both inoculum levels , the greatest reductions were seen after the first two weeks of storage, followed by a slower decline phase. The lowest reductions were verified in paçoca and roasted peanuts, with counts of 1.01 and 0.87 log cfu/ g at low inoculum level and 2.53 and 3.82 log cfu/ g at high inoculum level at the end of the storage time. The highest loss of viability was observed in pé-de-moça, with absence of Salmonella in 10-g after 180 days at low inoculum level. The Weibull model provided a suitable fit to the data (R 2 !0.81), with δ value ranging from 0.06 to 49.75 days. Therefore, the results demonstrated that Salmonella survives longer in peanut products, beyond the shelf life (>420 days), especially in products with a w around 0.40.

Feed has been identified as a vector of transmission for porcine epidemic diarrhea virus (PEDV). The objective of this study was to determine if feed batch sequencing methods could minimize PEDV cross-contamination. Porcine epidemic diarrhea virus-free swine feed was manufactured to represent the negative control. A 50 kg feed batch was mixed in a pilot scale feed mill for 5 min, sampled, then discharged for 10 min into a bucket elevator and sampled again upon exit. Next, a pathogenic PEDV isolate was used to inoculate 49.5 kg of PEDV-free feed to form the positive control. The positive control was mixed, conveyed and sampled similar to the negative control. Subsequently, 4 sequence batches (sequence 1 to 4) were formed by adding a 50 kg batch of PEDV-negative feed to the mixer after the prior batch was mixed and conveyed; all sequences were mixed, conveyed, and sampled similar to the negative and positive control batches. None of the equipment was cleaned between batches within a replicate. This entire process was replicated 3 times with cleaning the feed mill between replicates. Feed was then analyzed for PEDV RNA by real-time reverse transcriptase semiquantitative polymerase chain reaction (rRT-PCR) as measured by cycle threshold (Ct) and for infectivity by bioassay. Sequence 1 feed had higher (P ˂ 0.05) rRT-PCR Ct values than the positive batch and sequence 2 feed had higher (P ˂ 0.05) Ct values than sequence 1, regardless of sampled location. Feed sampled from the mixer from sequence 2, 3, and 4 was rRT-PCR negative whereas feed sampled from the bucket elevator was rRT-PCR negative from sequence 3 and 4. Bioassay was conducted using 66 mixed sex 10-d-old pigs confirmed negative for PEDV allocated to 22 different rooms. Pigs were initially 10-d old. Control pigs remained PEDV negative for the study. All pigs from the mixer positive batch (9/9) and bucket elevator positive batch (3/3) were rRT-PCR positive on fecal swabs by the end of the study. One replicate of pigs from mixer sequence 1 was rRT-PCR positive (3/3) by 7 dpi. One replicate of mixer pigs from sequence 2 was rRT-PCR positive (3/3) by 7 dpi although no detectable PEDV RNA was found in the feed. The results demonstrate sequenced batches had reduced quantities of PEDV RNA although sequenced feed without detectible PEDV RNA by rRT-PCR can be infectious. Therefore, a sequencing protocol can reduce but not eliminate the risk of producing infectious PEDV carryover from the first sequenced batch of feed.