No abstract

No abstract

No abstract

We present a low-frequency sensor for the detection of vibrations, with a sub-nm amplitude, based on a cantilever made of a single-crystalline lithium niobate (LiNbO3) plate, with a bidomain ferroelectric structure. The sensitivity of the sensor-to-sinusoidal vibrational excitations was measured in terms of displacement as well as of acceleration amplitude. We show a linear behavior of the response, with the vibrational displacement amplitude in the entire studied frequency range up to 150 Hz. The sensitivity of the developed sensor varies from minimum values of 20 μV/nm and 7 V/g (where g = 9.81 m/s2 is the gravitational acceleration), at a frequency of 23 Hz, to peak values of 92.5 mV/nm and 2443 V/g, at the mechanical resonance of the cantilever at 97.25 Hz. The smallest detectable vibration depended on the excitation frequency and varied from 100 nm, at 7 Hz, to 0.1 nm, at frequencies above 38 Hz. Sensors using bidomain lithium niobate single crystals, as sensitive elements, are promising for the detection of ultra-weak low-frequency vibrations in a wide temperature range and in harsh environments.

The method of development of the bidomain structure in single crystalline lithium niobate plates based on the creation of a given temperature gradient distribution through a sample thickness by stationary heating is considered. Heating the LiNbO 3 plate, which is placed between two silicon plates, is implemented by light energy emitted by lamps of the photonic annealing setup, which is absorbed by silicon. The scheme of the technological cell provides the formation and control over heat fluxes penetrating a ferroelectric plate and forming temperature gradients required for the controlled formation of two domains with the opposite polarization vectors (a head to head domain structure). The efficiency of light absorption for the formation of heat sources, which can be used for symmetric and asymmetric heating, which determines the position of the conditional surface with a zero temperature gradient and, consequently, a domain boundary position, is confirmed experimentally. In the LiNbO 3 plate with a thickness of 1.6 mm and length 60 mm, a symmetric bidomain structure with oppositely directed polarization vectors is formed. The dependence of the bending strain of a console clipped sample on electric voltage is studied in the temperature range -300 to +300 V; the strain amplitude is more than 35 µm. The high linearity and repeatability of the electric voltage-bending strain characteristic is shown.