No abstract

A plane strain problem for two piezoelectric half-spaces adhered by a very thin isotropic interlayer with a crack under the action of remote mixed mode mechanical loading and electrical flux is considered. The crack is situated either at an interface or in the interlayer. It is assumed that the substrates are much stiffer than the intermediate layer. Therefore, pre-fracture zones (plastic or damage) arise at the crack continuations. Normal and shear stresses are assumed to be constant in this zones and to satisfy some material equation, which can be taken from theory or derived experimentally. Modeling the pre-fracture zones by the crack continuations with unknown cohesive stresses on their faces reduces the problem to elastic interface crack analysis leading to a Hilbert problem. This problem is solved exactly. The pre-fracture zone lengths and stresses in these zones are found from algebraical and transcendental equations. The latter are derived from the conditions of stress finiteness at the ends of pre-fracture zones and the material equations. The electrical displacement at any point of the pre-fracture zones is found in closed form as well. Particular cases of symmetrical loading and of equivalent properties of the upper and lower bimaterial components are considered. Numerical results corresponding to certain material combinations and interlayer material equations are presented and analysed. In the suggested model, any singularities connected with the crack are eliminated, i.e., all mechanical and electrical characteristics are limited in the nearcrack tip region.

a b s t r a c tA plane problem for an electrically conducting interface crack in a piezoelectric bimaterial is studied. The bimaterial is polarized in the direction orthogonal to the crack faces and loaded by remote tension and shear forces and an electrical field parallel to the crack faces. All fields are assumed to be independent of the coordinate co-directed with the crack front. Using special presentations of electromechanical quantities via sectionally-analytic functions, a combined Dirichlet-Riemann and Hilbert boundary value problem is formulated and solved analytically. Explicit analytical expressions for the characteristic mechanical and electrical parameters are derived. Also, a contact zone solution is obtained as a particular case. For the determination of the contact zone length, a simple transcendental equation is derived. Stress and electric field intensity factors and, also, the contact zone length are found for various material combinations and different loadings. A significant influence of the electric field on the contact zone length, stress and electric field intensity factors is observed. Electrically permeable conditions in the crack region are considered as well and matching of different crack models has been performed.

a b s t r a c tA plane problem for two identical piezoelectric semi-infinite spaces adhered by means of a thin isotropic interlayer is considered. It is assumed that a crack of a limited electric permeability occurs in the interlayer parallel to its faces. Combined electromechanical loading is prescribed at infinity. It is assumed that the interlayer is softer than the adherent materials. To avoid the singularities, which are typical for the Griffith crack model, two distinct zones -a zone of mechanical yielding and a zone of electrical saturation -of unknown lengths are introduced as crack continuations. These lengths can be essentially different, with the zone of mechanical yielding significantly longer or shorter than the zone of electrical saturation. Assuming that the interlayer thickness tends to zero, a constant normal stress is prescribed in the zone of mechanical yielding and a saturated electrical displacement is prescribed in the zone of electrical saturation. Outside of these zones, the semi-infinite spaces are assumed to be perfectly bonded. This formulation results in a linear fracture mechanics problem with unknown pre-fracture zone lengths. The problem, formulated mathematically by a system of two equations of linear relationship, is solved exactly. The unknown yield and saturated zones lengths are found from the conditions of finiteness of stress and electrical displacement at the ends of these zones for the both cases when the electrical saturated zone is longer and shorter than the zone of mechanical yielding. It is shown that the same equation as for the Griffith crack model can be used for the determination of the electrical displacement in the crack region. The main results of the paper are obtained in the form of simple analytical equations which are convenient for engineering applications. Some numerical illustrations in graphical and tabular form show dependencies of the pre-fracture zone lengths, the energy release rate, the mechanical displacement and electrical potential jumps on the electromechanical loading and the electrical permeability of the crack medium.

No abstract