The thermodynamic temperature of the point of inflection of the melting transition of Re-C, Pt-C and Co-C eutectics has been determined to be 2747.84 ± 0.35 K, 2011.43 ± 0.18 K and 1597.39 ± 0.13 K, respectively, and the thermodynamic temperature of the freezing transition of Cu has been determined to be 1357.80 ± 0.08 K, where the ± symbol represents 95% coverage. These results are the best consensus estimates obtained from measurements made using various spectroradiometric primary thermometry techniques by nine different national metrology institutes. The good agreement between the institutes suggests that spectroradiometric thermometry techniques are sufficiently mature (at least in those institutes) to allow the direct realization of thermodynamic temperature above 1234 K (rather than the use of a temperature scale) and that metal-carbon eutectics can be used as high-temperature fixed points for thermodynamic temperature dissemination. The results directly support the developing mise en pratique for the definition of the kelvin to include direct measurement of thermodynamic temperature.

Early identification of areas of inflammation may aid prevention of diabetic foot ulcers. A new bespoke thermal camera system has been developed to thermally image feet at risk. Hotspots (areas at least 2.2 °C hotter than the contralateral site) may indicate areas of inflammation prior to any apparent visual signs. This article describes the thermal pattern and symmetry of 103 healthy pairs of feet. 68% of participants were thermally symmetric at the 33 foot sites measured. 32% of participants had at least one hotspot, but hotspots overall only accounted for 5% of the measurements made. Refinements to the definition of hotspots are proposed when considering feet at risk of ulceration.

Non-contact infra-red skin thermometers (NCITs) are becoming more prevalent for use in medical diagnostics. Not only are they used as an alternative means of estimating core body temperature but also to assess the diabetic foot for signs of inflammation prior to ulceration. Previous investigations have compared the performance of NCITs in a clinical setting against other gold standard methods. However, there have been no previous investigations comparing the performance of NCITs in assessing temperature measurement capability traceable to the International Temperature Scale of 1990 (ITS-90). A metrological assessment of nine common NCITs was carried out over the temperature range of 15-45 °C using the National Physical Laboratory's blackbody reference sources to identify their accuracy, repeatability, size-of-source and distance effects. The results are concerning in that five of the NCITs fell far outside the accuracy range stated by their manufacturers as well as the medical standard to which the NCITs are supposed to adhere. Furthermore, a 6 °C step change in measurement error over the temperature range of interest for the diabetic foot was found for one NCIT. These results have implications for all clinicians using NCITs for temperature measurement and demonstrate the need for traceable calibration to ITS-90.

Aim To assess the usefulness of monthly thermography and standard foot care to reduce diabetic foot ulcer recurrence. Methods People with diabetes (n = 110), neuropathy and history of ≥ 1 foot ulcer participated in a single‐blind multicentre clinical trial. Feet were imaged with a novel thermal imaging device (Diabetic Foot Ulcer Prevention System). Participants were randomized to intervention (active thermography + standard foot care) or control (blinded thermography + standard foot care) and were followed up monthly until ulcer recurrence or for 12 months. Foot thermograms of participants from the intervention group were assessed for hot spots (areas with temperature ≥ 2.2°C higher than the corresponding contralateral site) and acted upon as per local standards. Results After 12 months, 62% of participants were ulcer‐free in the intervention group and 56% in the control group. The odds ratios of ulcer recurrence (intervention vs control) were 0.82 (95% CI 0.38, 1.8; P = 0.62) and 0.55 (95% CI 0.21, 1.4; P = 0.22) in univariate and multivariate logistic regression analyses, respectively. The hazard ratios for the time to ulcer recurrence (intervention vs control) were 0.84 (95% CI 0.45, 1.6; P = 0.58) and 0.67 (95% CI 0.34, 1.3; P = 0.24) in univariate and multivariate Cox regression analyses, respectively. Conclusions Monthly intervention with thermal imaging did not result in a significant reduction in ulcer recurrence rate or increased ulcer‐free survival in this cohort at high risk of foot ulcers. This trial has, however, informed the design of a refined study with longer follow‐up and group stratification, further aiming to assess the efficacy of thermography to reduce ulcer recurrence.

The eutectic alloys rhenium-carbon, platinum-carbon and cobalt-carbon have been proposed as reference standards for thermometry, with temperature and uncertainty values specified within the mise en pratique of the definition of the kelvin. These alloys have been investigated in a collaboration of eleven national measurement institutes and laboratories. Published results reported the point-of-inflection in the melting curve with extremely low uncertainties. However, to be considered as standards it is necessary to stipulate what phenomenon a temperature value has been ascribed to; specifically, this should be a thermodynamic state. Therefore, the data have been further evaluated and the equilibrium liquidus temperatures determined based on a consideration of limits and assuming a rectangular probability distribution. The values are: for rhenium-carbon 2747.91 ± 0.44 K, for platinum-carbon 2011.50 ± 0.22 K and for cobalt-carbon 1597.48 ± 0.14 K, with uncertainties at approximately a 95% coverage probability. It is proposed that these values could be used as Metrologia