When enzymes are optimized for biotechnological purposes, the goal often is to increase stability or catalytic efficiency. However, many enzymes reversibly convert their substrate and product, and if one is interested in catalysis in only one direction, it may be necessary to prevent the reverse reaction. In other cases, reversibility may be advantageous because only an enzyme that can operate in both directions can turnover at a high rate even under conditions of low thermodynamic driving force. Therefore, understanding the basic mechanisms of reversibility in complex enzymes should help the rational engineering of these proteins. Here, we focus on NiFe hydrogenase, an enzyme that catalyzes H(2) oxidation and production, and we elucidate the mechanism that governs the catalytic bias (the ratio of maximal rates in the two directions). Unexpectedly, we found that this bias is not mainly determined by redox properties of the active site, but rather by steps which occur on sites of the proteins that are remote from the active site. We evidence a novel strategy for tuning the catalytic bias of an oxidoreductase, which consists in modulating the rate of a step that is limiting only in one direction of the reaction, without modifying the properties of the active site.

Using direct electrochemistry to learn about the mechanism of electrocatalysts and redox enzymes requires that kinetic models be developed. Here we thoroughly discuss the interpretation of electrochemical signals obtained with adsorbed enzymes and molecular catalysts that can reversibly convert their substrate and product. We derive analytical relations between electrochemical observables (overpotentials for catalysis in each direction, positions, and magnitudes of the features of the catalytic wave) and the characteristics of the catalytic cycle (redox properties of the catalytic intermediates, kinetics of intramolecular and interfacial electron transfer, etc.). We discuss whether or not the position of the wave is determined by the redox potential of a redox relay when intramolecular electron transfer is slow. We demonstrate that there is no simple relation between the reduction potential of the active site and the catalytic bias of the enzyme, defined as the ratio of the oxidative and reductive limiting currents; this explains the recent experimental observation that the catalytic bias of NiFe hydrogenase depends on steps of the catalytic cycle that occur far from the active site [Abou Hamdan et al., J. Am. Chem. Soc. 2012, 134, 8368]. On the experimental side, we examine which models can best describe original data obtained with various NiFe and FeFe hydrogenases, and we illustrate how the presence of an intramolecular electron transfer chain affects the voltammetry by comparing the data obtained with the FeFe hydrogenases from Chlamydomonas reinhardtii and Clostridium acetobutylicum, only one of which has a chain of redox relays. The considerations herein will help the interpretation of electrochemical data previously obtained with various other bidirectional oxidoreductases, and, possibly, synthetic inorganic catalysts.