In this paper, the major factors that affect the performance of wireless power transfer systems, such as coil inner radius and coil number of turns, are discussed. A comparison of three coil shapes covering the coreless case, the case with ferrite, and the case with ferrite and aluminum is also carried out. Another comparison is proposed by addressing the combination of different coil shapes in the wireless power transfer (WPT)system. The analysis covers the coupling coefficient, the mutual inductance, and the self-inductance. Due to the complexity of calculating these parameters, the finite element analysis (FEA) method is adopted by using the Ansys Maxwell software. An introduction to the typical WPT system for electric vehicle charging is also presented.

No abstract

Wireless power transfer (WPT) chargers are promising solutions for charging electric vehicles (EVs). Due to their advantages such as ease and safety of use, these chargers are increasingly replacing conductive ones. In this paper, we first provide a detailed analysis to illustrate the effect of varying parameters on the operation of the WPT charger. Secondly, we present the main design steps of the charger elements while respecting the recommendations of the SAEJ2954 standard in terms of operating frequency, efficiency and misalignments. Regarding the design of the ground-side and vehicle-side coils, we propose three different circular geometries whose parameters are determined using an iterative approach. The latter is compared with a finite element analysis performed under Ansys Maxwell software showing the convergence between theoretical calculations and the simulation results. Finally, an experimental prototype with a power of 500 W is realized. In addition, different test scenarios are performed to validate the proposed design approach. In this respect, an efficiency of 90% is obtained for a power of 500 W and a distance between coils of 125 mm. Moreover, the test of the charger in the most unfavorable operating case (misalignments of Δx = 70 mm, Δy = 10 mm and Δz = 150 mm) gives an efficiency of 83.5%, which remains above the limit of the SAEJ2954 standard.

No abstract

This research work deals with the problem of controlling a salient-pole permanent-magnet synchronous motor (SP-PMSM) used in hybrid electric vehicles. An adaptive nonlinear controller based on the backstepping technique is developed to meet the following requirements: control of the reference vehicle speed in the presence of load variation and changes in the internal motor parameters while keeping the reliability and stability of the vehicle. The complexity of the control problem lies on the system nonlinearity, instability and the problem of inaccessibility to measure all the internal parameters, such as inertia, friction and load variation. For this issue, an adaptive backstepping regulator is developed to estimate these parameters. On the basis of formal analysis and simulation, as well as test results, it is clearly shown that the designed controller achieves all the goals, namely robustness and reliability of the controller, stability of the system and speed control, considering the uncertainty parameters’ measurements.