Porous organic polymers (POPs) have been considered as prominent adsorbents for volatile iodine. So far, both crystalline and amorphous POPs have accomplished excellent iodine capture capability. Considering the difficulty and challenges in preparing perfect crystalline POPs, more explorations into developing versatile amorphous POPs are needed. Herein, amorphous POPs based on the Schiff-base reaction were designed and synthesized for volatile iodine removal. Four amorphous POPs products named as NDB-H, NDB-S, ADB-HS, and ADB-S obtained under different solvothermal conditions were investigated in terms of their morphologies, porosity, and their iodine enrichment performance in detail. It is noteworthy that excellent efficiency for removing iodine vapor was acquired for NDB-S (≈425 wt %), ADB-HS (≈345 wt %), and ADB-S (≈342 wt %). Remarkably, NDB-H exhibited an iodine capture capacity up to ≈443 wt %. Excellent reusability was obtained as well. Amorphous NDB-H has accomplished an extremely high iodine capture performance, illustrating the great chance to exploit versatile amorphous POPs for iodine enrichment and removal based on Schiff-base chemistry.

No abstract

No abstract

No abstract

To prepare silica/rubber composites for low roll resistance tires, a novel strategy was proposed in this study, in which autonomous monodisperse silica (AS) was prepared and modified using 3-mercaptopropyloxy-methoxyl-bis(nonane-pentaethoxy) siloxane (Si747), after which silica/emulsion styrene butadiene rubber (ESBR) master batches were produced using the latex compounding technique. Meanwhile, the commercial precipitated silica (PS) was introduced as a control. In this study, the effects of amount of Si747 and pH value on the properties of the silica/ESBR composites were systematically analyzed. Thermal gravimetric analysis (TGA) and Fourier transform infrared (FTIR) results indicated that Si747 reduced the silanol group by chemical grafting and physical shielding, and the optimum amounts of Si747 for AS and PS modification were confirmed to be 15% and 20%, respectively. Under a pH of 9, ESBR/modified AS (MAS) composites with 15% Si747 presented better silica dispersion and a weaker Payne effect, compared with ESBR/modified PS (MPS) composites with 20% Si747. Meanwhile, in terms of dynamic properties, the ESBR/MAS composites exhibited a better balance of lower rolling resistance and higher wet skid resistance than the ESBR/MPS composites.