Due to rapid changes in food habits, a substantial amount of waste fat and used oils are generated each year. Due to strong policies, the disposal of this material into nearby sewers causes ecological and environmental problems in many parts of the world. For efficient management, waste cooking oil, a less expensive, alternative and promising feedstock, can be used as a raw material for producing biofuel. In the present study, we produced a biodiesel from hydrolyzed waste cooking oil with a subcritical methanol process using a synthesized solid super acid catalyst, a sulfated zirconium oxide supported on Santa Barbara Amorphous silica (S-ZrO 2 /SBA-15). The characterization of the synthesized catalyst was carried out using scanning electron microscopy (SEM), X-ray diffraction (XRD), and the Brunauer-Emmett-Teller (BET) method. The catalytic effect on biodiesel production was examined by varying the parameters: temperatures of 120 to 200 • C, 5-20 min times, oil-to-methanol mole ratios between 1:5 to 1:20, and catalyst loadings of 1-2.5%. The maximum biodiesel yield was 96.383%, obtained under optimum reaction conditions of 140 • C, 10 min, and a 1:10 oil-to-methanol molar ratio with a 2.0% catalyst loading. We successfully reused the catalyst five times without regeneration with a 90% efficiency. The fuel properties were found to be within the limits set by the biodiesel standard.

Due to uncontrolled consumption of fossil fuel it is necessary to use alternative resources as renewable energy. Among all the available liquid fuels biodiesel has drawn attention for producing less emissions and having less aromatic contents than diesel and because it can also be obtained from inferior grade feedstocks. Since the various uses of fats and oils have increased, a significant amount of waste animal fat and used edible oil is generated every year. In this work, we produced biodiesel from littered edible oil fraction (LEOF) via hydrolysis followed by catalytic esterification. Nearly 90% free fatty acids (FFA) content was achieved at 275 • C, after 45 min during hydrolysis and linoleic acid (C18:2) was observed to be the highest component. Compared to refined soybean oil (SBO) the reaction rate was accelerated by the auto-catalytic behavior of free fatty acids (FFA) in littered edible oil fraction (LEOF). For catalytic esterification, S-TiO 2 /MCM-41 catalyst was directly synthesized and characterized by using XRD, SEM, NH 3 -TPD and Brunauer Emmett Teller (B.E.T). The parameters such as; SO 4 −2 content, TiO 2 loading and calcination temperature were varied to get optimum free fatty acids (FFA) conversion. Fatty acid methyl ester (FAME) conversion was 99.29% using 1% S-TiO 2 /MCM-41 catalyst at 240 • C whereas 86.18% was observed with 3.5% catalyst at 180 • C with 20 min. Thus, using S-TiO 2 /MCM-41 catalyst in esterification via hydrolysis would be a better option for treating low quality feedstocks.