No abstract

BackgroundThe selective lignin-degrading white-rot fungi are regarded to be the best lignin degraders and have been widely used for reducing the saccharification recalcitrance of lignocellulose. However, the biological delignification and conversion of lignocellulose in biorefinery is still limited. It is necessary to develop novel and more efficient bio-delignification systems.Results Physisporinus vitreus relies on a new versatile peroxidase (VP)-based delignification strategy to remove enzymatic recalcitrance of corn stover efficiently, so that saccharification of corn stover was significantly enhanced to 349.1 mg/g biomass (yield of glucose) and 91.5% (hydrolysis yield of cellulose) at 28 days, as high as levels reached by thermochemical treatment. Analysis of the lignin structure using pyrolysis–gas chromatography–mass spectrometry (Py–GC/MS) showed that the total abundance of lignin-derived compounds decreased by 54.0% and revealed a notable demethylation during lignin degradation by P. vitreus. Monomeric and dimeric lignin model compounds were used to confirm the ligninolytic capabilities of extracellular ligninases secreted by P. vitreus. The laccase (Lac) from P. vitreus could not oxidize nonphenolic lignin compounds and polymerized β-O-4 and 5-5′ dimers to precipitate which had a negative effect on the enzymatic hydrolysis of corn stover in vitro. However, the VP from P. vitreus could oxidize both phenolic and nonphenolic lignin model compounds as well as break the β-O-4 and 5-5′ dimers into monomeric compounds, which were measured by high-performance liquid chromatography–electrospray ionization–mass spectrometry (LC–ESI–MS). Moreover, we showed that addition of purified VP in vitro improved the enzymatic hydrolysis of corn stover by 14.1%.ConclusionsFrom the highly efficient system of enzymatic recalcitrance removal by new white-rot fungus, we identified a new delignification strategy based on VP which could oxidize both phenolic and nonphenolic lignin units and break different linkages in lignin. In addition, this is the first evidence that VP could break 5-5′ linkage efficiently in vitro. Moreover, VP improved the enzymatic hydrolysis of corn stover in vitro. The remarkable lignin-degradative potential makes VP attractive for biotechnological applications.Electronic supplementary materialThe online version of this article (doi:10.1186/s13068-017-0906-x) contains supplementary material, which is available to authorized users.

The removal of hazardous dyes has become a major economic and health concern to treat wastewater. In this study, efficient, low-cost, and eco-friendly spent mushroom waste (SMW) showed great potential for removing the anionic dyes, namely Direct Red 5B (DR5B), Direct Black 22 (DB22), Direct Black 71 (DB71), and Reactive Black 5 (RB5). The mechanisms of adsorption could be controlled by both physical and chemical adsorption. Scanning electron microscope analysis showed that SMW surface is porous and irregular. The kinetic study could be described well with the pseudo-second-order kinetic model, whereas the best representation of the equilibrium isotherm is the Langmuir model. The maximum adsorption capacities of SMW were found to be 18 mg g−1 for DR5B, 15.46 mg g−1 for DB22, 20.19 mg g−1 for DB71, and 14.62 mg g−1 for RB5. The analysis of thermodynamic study of ΔG°, ΔH°, and ΔS° proved that the adsorption of the tested dyes onto SMW was endothermic and spontaneous. Based on these results, SMW can be considered as high potential adsorbent for the removal of dyes from wastewater.

The treatment of wastewater always demands eco-friendly and cost-efficient adsorbents. In this paper, spent mushroom waste (SMW) was modified by a cationic surfactant (cetyltrimethylammonium bromide, CTAB) to eliminate toxic dyes. A characterization of adsorbents confirmed that CTAB was successfully embedded into the SMW structure. The spent mushroom waste, modified by CTAB (SMWC), exhibited an excellent adsorption capacity of 249.57 mg·g−1, 338.67 mg·g−1, and 265.01 mg·g−1 for the Direct red 5B (DR5B), Direct blue 71 (DB71), and Reactive black (RB5) dyes, respectively. Batch experiments indicated that the dye adsorption of SMWC depended mainly on pH, dye concentration, temperature, and ionic strength. The adsorption isotherm could be fitted to the Langmuir model and described by the pseudo-second-order kinetic model. The dye adsorption mechanism was dominated mostly by the chemosorption of the dyes and the SMWC surface. Thermodynamic parameters showed that the adsorption was endothermic and spontaneous. SMWC could successfully remove over 90% of dyes from various water samples. This can be considered a feasible waste resource utility, since it meets both the ecological and the economic requirements for auspicious industrial applications.