Polypyrrole (PPy) has unique features such as easy synthesis, environmental stability, and high electrical conductivity (approximately 105 S/cm and even >380 S/cm) for bulk and thin‐film materials. Thus, PPy is applied in numerous well‐established applications, such as in sensors, supercapacitors, and resonators. These applications take advantage of the unique properties achieved through the structure and properties of PPy. This article comprehensively elaborates the methods used to synthesize conductive PPy, along with the important factors affecting its conductivity. Emphasis is given to versatile and basic approaches that enable control of the microstructural features that eventually determine PPy conductivity. Despite the intensive research in this area, no previous study has presented all possible relevant information about PPy fabrication and the important factors influencing its electrical conductivity.

aThis study was conducted to evaluate the possibility of utilizing kenaf (KNF) in LLDPE/PVOH to develop a new thermoplastic composite. The effect of KNF loading on the processability and mechanical, thermal and water absorption properties of linear low-density polyethylene/poly (vinyl alcohol)/kenaf (LLDPE/PVOH/KNF) composites were investigated. Composites with different KNF loadings (0, 10, 20, 30, and 40 phr) were prepared using a Thermo Haake Polydrive internal mixer at a temperature of 150 °C and rotor speed of 50 rpm for 10 min. The results indicate that the stabilization torque, tensile modulus, water uptake, and thermal stability increased, while tensile strength and elongation at break decreased with increasing filler loading. The tensile fractured surfaces observed by scanning electron microscopy (SEM) supported the deterioration in tensile properties of the LLDPE/PVOH/KNF composites with increasing KNF loading.

No abstract

No abstract

aComposites containing linear low-density polyethylene/polyvinyl alcohol and various loadings of kenaf fiber were prepared using a Haake internal mixer. The loading of kenaf fiber varied from 10 to 40 parts per hundred resin (phr). The coupling agent 3-(trimethoxysilyl)propyl methacrylate (TMS) was evaluated for its effect on the processing torque, tensile properties, morphology, water resistance, and thermal properties of the composites. Composites without TMS were used as the control. The composites made from TMS-treated kenaf yielded higher stabilization torque, tensile strength, tensile modulus, water resistance, and thermal properties than the control composites. The improvements were attributed to the coupling effect of TMS.