In recent times, Triboelectric Nanogenerators (TENG) have attained the focus of the scientific community due to its potential as a medium to harvest mechanical energy from the ambient environment. Human motion has been attributed as a source of mechanical energy to drive electronic devices and sensors through TENG. Based on the principles of single electrode TENG, we have developed a Triboelectricity based Stepping and Tapping Energy Case (TESTEC) which magnifies the prospect to power touch electronic devices by utilizing finger tapping and stepping motion. This novel case was constructed with two single electrode TENG operating through the triboelectric mechanism between human skin and Polyethylene terephthalate(PET) film on the front part and Nitrile Butadiene Rubber(NBR) and PET film on the back part. This cost effective device was further tested by attaching with a cell phone at variable load frequency, airgap and finger combinations where the output response increased with the increased frequencies (60 to 240 BPM) and air gap (1cm to 5cm). Maximum output voltages of 14.8 V and 50.8 V were obtained for the front and back parts, respectively. Besides, maximum output powers were observed to be 3.78 W/m 2 at 0.46 MΩ and 6.21 W/m 2 at 1.02 MΩ, respectively. Also, the device was tested by integrating with conventional electronic components including capacitors, bridge rectifiers and 15 LEDs. Based on the results, a electrical circuit has been proposed to power touch cell phones. The device was further modified using Silver (Ag) nanoparticles in the front part. The modified TESTEC provided higher output response compared to the primary TESTEC. The TESTEC can be a self sustainable way to power touch electronic devices which can reudce the necessity to charge electronics devices in the conventional way.
The self‐powered and autonomous sensors are incredibly important in advanced engineering, especially defence science. The increasing necessity of simple and smart electronics requires to be sustainably flexible, wearable, and waterproof. Triboelectricity has been a widely used mechanism for motion sensing nowadays. Almost all devices based on triboelectricity require contact between two surfaces. Herein, a touchless triboelectric motion sensor for human motion sensing and movement monitoring is developed. The device was primarily fabricated using simple latex (cis‐1,4‐polyisoprene) structures and copper (electrode materials), which make it a very cost‐effective device for sensory applications. The device is tested with specimens of different areas and heights in motion. The maximum output of the device is noted as 12 V at a specimen height of 5 cm. Further different types of human motions are applied in front of the device to ensure low energy sensitivity using triboelectric phenomena. The lightweight smart device precisely provides significant output signals for each movement of the human body which makes the device a prospective medium for motion sensing and movement monitoring which can be applied in the fields of security, energy, and medicine.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.