No abstract

This paper describes the development of laser produced plasma (LPP) technology as an EUV source for advanced scanner lithography applications in high volume manufacturing. EUV lithography is expected to succeed 193 nm immersion technology for critical layer patterning below 32 nm beginning with beta generation scanners in 2009. This paper describes the development status of subsystems most critical to the performance to meet joint scanner manufacturer requirements and semiconductor industry standards for reliability and economic targets for cost of ownership. The intensity and power of the drive laser are critical parameters in the development of extreme ultraviolet LPP lithography sources. The conversion efficiency (CE) of laser light into EUV light is strongly dependent on the intensity of the laser energy on the target material at the point of interaction. The total EUV light generated then scales directly with the total incident laser power. The progress on the development of a short pulse, high power CO 2 laser for EUV applications is reported.The lifetime of the collector mirror is a critical parameter in the development of extreme ultra-violet LPP lithography sources. The deposition of target materials and contaminants, as well as sputtering of the collector multilayer coating and implantation of incident particles can reduce the reflectivity of the mirror substantially over the exposure time even though debris mitigation schemes are being employed. The results of measurements of high energy ions generated by a short-pulse CO 2 laser on a laser-produced plasma EUV light source with Sn target are presented. Droplet generation is a key element of the LPP source being developed at Cymer for EUV lithography applications. The main purpose of this device is to deliver small quantities of liquid target material as droplets to the laser focus. The EUV light in such configuration is obtained as a result of creating a highly ionized plasma from the material of the droplets. Liquid tin is the material of choice to be used as a target due to the relatively high CE of the laser energy into in-band EUV radiation. Results obtained with the droplet generator and technical challenges related to successful implementation of the device are discussed.

Metrology concepts and related results are discussed for characterization of extreme ultraviolet (EUV) light sources based on laser-produced plasmas using metal foil and droplet targets. Specific designs of narrow-band EUV detectors employing multilayer mirrors and broadband detectors for droplet steering are described. Spatially resolved plasma imaging using in-band EUV pinhole cameras is discussed. A grazing-incidence flat-field EUV spectrometer is described that has been employed for spectroscopy in the 6 nm -22 nm range. In addition, spectroscopic data of out-of-band radiation in the ultraviolet and visible spectral regions are presented. Results obtained for different wavelengths of the incident laser radiation and for both tin-and lithium foil-and droplet-targets are discussed.

Efficient conversion of laser light into EUV radiation is one of the most important problems of the laser-produced plasma (LPP) EUV source. Too low a conversion efficiency (CE) increases the amount of power the drive laser will have to deliver, which, besides the obvious laser cost increase, also increases the thermal load on all the components and can lead to increased debris generation. In order to meet the requirements for a high-volume manufacturing (HVM) tool and at the same time keep the laser power requirements within acceptable limits, a CE exceeding 2.5% is likely to be required. We present our results on optimizing conversion efficiency of LPP EUV generation. The optimization parameters include laser wavelength, target material, and laser pulse shape, energy and intensity. The final choice between parameter sets that leads to the required minimum CE is dependent on the debris mitigation solutions and the laser source available for a particular parameter set.

No abstract