No abstract

No abstract

The energy spread of the electron beam is a critical parameter in x-ray free-electron lasers (XFELs) and needs to be optimized for best performance. The uncorrelated energy spread of the electrons can be a few keV or less in XFEL injectors, thus very challenging to measure. The standard method to characterize the electron beam energy spread, consisting in streaking the beam with a transverse deflector and measuring the time-resolved beam size of the electrons in a dispersive location for a single electron beam energy, has a typical resolution of several keV. To overcome this limitation we introduce a novel method to measure the beam size at a dispersive location for different beam energies so that it is possible to disentangle the beam size contributions related to the energy spread, the intrinsic beam size and the monitor resolution. As a consequence, the energy spread can be characterized with a much higher precision and resolution than in the standard approach. We also suggest to perform measurements for different deflection amplitudes so that the energy spread induced by the transverse deflector can be subtracted properly. The scheme does not require any additional hardware and thus can be readily applied in any standard XFEL facility. Numerical simulations and experimental results at SwissFEL confirm the validity of our method. Our calculations show that the approach can be used to significantly overcome the resolution of the standard approach and measure energy spreads well below 1 keV. As an example we present energy spreads of few keV measured at the SwissFEL injector.

The transverse emittance of the electron beam is a fundamental parameter in linac-based x-ray freeelectron lasers (FELs). We present results of emittance measurements carried out at SwissFEL, a compact x-ray FEL facility at the Paul Scherrer Institute in Switzerland, including a description of the novel highresolution measurement techniques and the optimization procedure. We obtained slice emittance values at the undulator entrance down to 200 nm for an electron beam with a charge of 200 pC and an rms duration of 30-40 fs. Furthermore, we achieved slice emittances as low as 100 nm for 10 pC beams with few fs duration. These values set new standards for electron linear accelerators. The quality, verification, and control of our electron beams allowed us to generate high-power FEL radiation for a wavelength as short as 0.1 nm using an electron beam with an energy of only 6 GeV. The emittance values demonstrated at SwissFEL would allow producing hard x-ray FEL pulses with even lower-energy beams, thus paving the way for even more compact and cost-effective FEL facilities.

We present a novel compact design for a multichannel atomic oven which generates collimated beams of refractory atoms for fieldable laser spectroscopy. Using this resistively heated crucible, we demonstrate spectroscopy of an erbium sample at 1300 °C with improved isotopic resolution with respect to a single-channel design. In addition, our oven has a high thermal efficiency. By minimizing the surface area of the crucible, we achieve 2000 °C at 140 W of applied electrical power. As a result, the design does not require any active cooling and is compact enough to allow for its incorporation into fieldable instruments.