N -glycans are important players in a variety of pathologies including different types of cancer, (auto)immune diseases, and also viral infections. Matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) is an important tool for high-throughput N -glycan profiling and, upon use of tandem MS, for structure determination. By use of MALDI-MS imaging (MSI) in combination with PNGase F treatment, also spatially correlated N -glycan profiling from tissue sections becomes possible. Here we coupled laser-induced postionization, or MALDI-2, to a trapped ion mobility quadrupole time-of-flight mass spectrometer (timsTOF fleX MALDI-2, Bruker Daltonics). We demonstrate that with MALDI-2 the sensitivity for the detection of molecular [M – H] − species of N- glycans increased by about 3 orders of magnitude. Compared to the current gold standard, the positive ion mode analysis of [M + Na] + adducts, a sensitivity increase by about a factor of 10 is achieved. By exploiting the advantageous fragmentation behavior of [M – H] − ions, exceedingly rich structural information on the composition of complex N -glycans was moreover obtained directly from thin tissue sections of human cerebellum and upon use of low-energy collision-induced dissociation tandem MS. In another set of experiments, in this case by use of a modified Synapt G2-S QTOF mass spectrometer (Waters), we investigated the influence of relevant input parameters, in particular pressure of the N 2 cooling gas in the ion source, delay between the two laser pulses, and that of their pulse energies. In this way, analytical conditions were identified at which molecular ion abundances were maximized and fragmentation reactions minimized. The use of negative ion mode MALDI-2-MSI could constitute a valuable tool in glycobiology research.

A recently introduced technique based on MALDI with laser-induced postionization (PI), also named MALDI-2, increases the ion yields for numerous classes of lipids, metabolites, and carbohydrates in MALDI-MS imaging experiments under certain experimental conditions. Here, we used a semiautomatic LabVIEW-based protocol to investigate and optimize the efficiency of the PI process dependent on four relevant input parameters and a dense parameter grid: pulse energies of the two lasers, delay between the laser pulses, and buffer gas pressure in the ion source. All experiments were conducted with a modified MALDI-2 Synapt G2-S mass spectrometer (Waters) and use of a focal spot size on the sample of 15–17 μm. A wavelength-tunable optical parametric oscillator (OPO) laser served for PI at 260 or 280 nm. The investigated MALDI matrices were: 2,5-dihydroxybenzoic acid (positive ion mode, +), 2,5-dihydroxyacetophenone (+), α-cyano-4-hydroxycinnamic acid (+), norharmane (negative-ion mode, −), and 1,5-diaminonapthalene (−). A porcine brain extract served as lipid standard. In the positive-ion mode, a maximum boost for the generated [M + H]+ species was found with a N2 buffer gas pressure of ∼2 mbar and a delay between the laser emissions of ∼10 μs. Higher optimal delay settings of several 10 μs were registered for the two studied matrices in negative-ion mode. With regard to the laser fluences, best PI efficiencies were reached using maximum available ablation and PI laser pulse energies of up to 25 and 160 μJ, respectively. For analytes not profiting from MALDI-2, best ion signal yields were recorded for ablation laser pulse energies of around 7 μJ, depending on the MALDI matrix. At higher laser pulse energies, sizable fragmentation is observed for these ions. The PI laser pulse energy did not have any influence on the ion signals of these species. For optimal ion yield of all analyte species, best results were obtained with an ablation laser pulse energy of ∼7 μJ and a PI laser pulse energy of ∼160 μJ. Our comprehensive data set provides valuable insight into the mechanisms underlying the MALDI-2 processes and could help to further optimize this emerging technique.

Ultraviolet matrix-assisted laser desorption ionization mass spectrometry imaging (UV-MALDI-MSI) is a powerful tool to visualize bacterial metabolites in microbial colonies and in biofilms. However, a challenge for the method is the efficient extraction of analytes from deeper within the bacterial colonies and from the cytoplasm of individual cells during the matrix coating step. Here, we used a pulsed infrared (IR) laser of 2.94 μm wavelength to disrupt and ablate bacterial cells without a prior coating with a MALDI matrix. Instead, tissue water or, in some experiments, in addition a small amount of glycerol was exploited for the deposition of the IR laser energy and for supporting the ionization of the analytes. Compared to water, glycerol exhibits a lower vapor pressure, which prolonged the available measurement time window within an MSI experiment. Mass spectra were acquired with a hybrid Synapt G2-S HDMS instrument at a pixel size of 120 μm. A frequencyquadrupled q-switched Nd:YAG laser with 266 nm wavelength served for laser-induced postionization (MALDI-2). In this way, the ion abundances of numerous small molecules such as nucleobases, 2-alkyl-quinolones, a prominent class of Pseudomonas aeruginosa signaling molecules involved in one of the three quorum-sensing pathways, and also the signals of various bacterial phospholipids were boosted, partially by orders of magnitude. We analyzed single and cocultured colonies of Gram-negative P. aeruginosa and of Gram-positive Bacillus subtilis and Staphylococcus aureus as exemplary bacterial systems. To enable a rapid (within 5 s) MSIcompatible steam inactivation in a custom-made autoclave filled with hot water steam, bacterial cultures were grown on porous polyamide membranes. Compared to a UV-MALDI-2-MS measurement of the same systems, mass spectra with a reduced low mass background were generally generated. This resulted in the unequivocal detection of numerous metabolites only with the IR laser. In a fundamental part of our study, and to optimize the IR-MALDI-2 approach for the highest analytical sensitivity, we characterized the expansion dynamics of the particle plume as generated by the IR laser. Here, we recorded the total ion count and the intensities of selected signals registered from P. aeruginosa samples as a function of the interlaser delay and buffer gas pressure in the ion source. The data revealed that the IR-MALDI-2 ion signals are primarily generated from slow particles having mean velocities of ∼10 m/s. Interestingly, two different pressure/delay time regimes of the optimized ionization efficiency for phospholipids and smaller metabolites, respectively, were revealed, a result pointing to yet-unknown convoluted reaction cascades. The described IR-MALDI-2 method could be a helpful new tool for a microbial mass spectrometry imaging of small molecules requiring little sample preparation.

MALDI-2 is a recently introduced technique for postionization (PI) in matrix-assisted laser desorption/ionization (MALDI). It is based on an initial photoionization of neutrally desorbed matrix molecules and subsequent charge-transfer reactions in a fine vacuum or atmospheric pressure ion source. MALDI-2 significantly increases the ion yields for numerous classes of analytes, including lipids, glycans, and a range of pharmaceuticals. To obtain insights into the ionization mechanisms underlying the primary step of PI in MALDI-2, we here conducted a set of experiments with two lasers at 266 nm wavelength and pulse durations of 28 ps and 6 ns, respectively, on a modified orthogonal-extracting time-of-flight mass spectrometer (QTOF, Synapt). 2,5-Dihydroxybenzoic acid (DHB) and 2,5-dihydroxyacetophenone (DHAP) were investigated as MALDI matrices in the positive-ion mode with standardized lipid samples. Analyte- and matrix-derived ion signals were recorded as a function of PI laser pulse energies. The ion signal intensity displays a quadratic dependency on PI-laser pulse energy for low to moderate intensities of up to ∼107 W/cm2. This behavior suggests the involvement of resonance enhanced two-photon ionization (REMPI) of neutral matrix molecules in the ionization pathways. Comparing nanosecond and picosecond pulses at the same PI laser pulse energy, higher photon density produced by the shorter pulses generally produced sizably higher ion signal intensities, also corroborating an involvement of REMPI-like processes. Based on a theoretical description of the MALDI-2 process derived from prevalent REMPI theory, comparative measurements allow us to determine the lifetime of the excited states of the employed matrices. Resulting values for both matrices are in good agreement with the literature and corroborate the REMPI-based approach.