No abstract

The mechanical and hydrodynamic phenomena occurring in the refining zones of disc refiners cause fibres to undergo fibrillation. This paper presents a study of the changes occurring during fibre fibrillation as expressed in terms of the fibrillation index when refining pulp with a 10%, 15%, and 20% consistency. The influences of the tangential force of a circular bar and a straight bar on fibre fibrillation were compared. The changes in the tangential force are shown to depend on the angle between the tangent to the cutting edge and the radius from the centre of the disk to the tangency point. Increasing the angle between the tangent to the cutting edge and the radius from the centre of the disk to the tangency point gives higher fibrillation index values. The study revealed a relationship between fibre fibrillation and the strength characteristics of handsheets.

Transportation of high concentrated fibrous materials to the disk mill grinding zone may be accompanied by problems when the fibrous material clogs the knife gap and causes subsequent failure of the grinding equipment. The article considers one of the few recommendations helping to eliminate this negative effect taking into account main technological factors of the grinding process.