Nanostructured ferritic alloys are a new class of ultrafine-grained oxide dispersionstrengthened steels that have promising properties for service in extreme environments in future nuclear reactors. This is due to the remarkable stability of their complex microstructures containing numerous Y-Ti-O nanoclusters within grains and along grain boundaries. Although nanoclusters account primarily for the exceptional resistance to irradiation damage and high-temperature creep, little is known about the mechanical roles of the polycrystalline grains that constitute the ferritic matrix. Here we report an in situ mesoscale characterization of anisotropic responses of ultrafine ferrite grains to stresses using state-ofthe-art neutron diffraction. We show the experimental determination of single-crystal elastic constants for a 14YWT alloy, and reveal a strong temperature-dependent elastic anisotropy that leads to elastic softening and instability of the ferrite. We also demonstrate, from anisotropy-induced intergranular strains, that a deformation crossover exists from lowtemperature lattice hardening to high-temperature lattice softening in response to extensive plastic deformation.

Abstract

The problem of calculating the inverse pole figure (IPF) is analyzed from the perspective of the application of time‐of flight neutron diffraction to in situ monitoring of the thermomechanical behavior of engineering materials. On the basis of a quasi‐Monte Carlo (QMC) method, a consistent set of grain orientations is generated and used to compute the weighting factors for IPF normalization. The weighting factors are instrument dependent and were calculated for the engineering materials diffractometer VULCAN (Spallation Neutron Source, Oak Ridge National Laboratory). The QMC method is applied to face‐centered cubic structures and can be easily extended to other crystallographic symmetries. Examples include 316LN stainless steel in situ loaded in tension at room temperature and an Al–2%Mg alloy, substantially deformed by cold rolling and in situ annealed up to 653 K.

BWAVES is an acronym for Broadband Wide-Angle VElocity Selector spectrometer, indicating that a novel WAVES (Wide-Angle VElocity Selector) device will be used to select the velocity/wavelength of the detected neutrons after they are scattered by the sample. We describe a conceptual design of BWAVES, a time-of-flight broadband inverted-geometry neutron spectrometer for the Second Target Station at the Spallation Neutron Source operated by Oak Ridge National Laboratory. Being the first inverted geometry spectrometer where the energy of the detected neutrons can be chosen by a WAVES device mechanically, irrespective of the limitations imposed by the crystal analyzers or filters, BWAVES will feature a uniquely broad, continuous dynamic range of measurable energy transfers, spanning 4.5 decades. This will enable measurements of both vibrational and relaxational excitations within the same, continuous scattering spectra. Novel approaches that are necessary for the implementation of a WAVES device at the BWAVES spectrometer will result in a spectrometer with the design and characteristics much different from those displayed by the neutron spectrometers in existence today.

No abstract