In recent years, food products manufactured with buckwheat and sprouts flours have attracted widespread interest due to their high nutritional value with various health benefits, becoming more and more popular. The purpose of this study was to assesses the influence of buckwheat and sprouts flours on the nutritional, sensorial and textural characteristics on the final baked products. In order to achieve these goals, methods like HPLC-RID (High-Perfomance Liquid Chromatography with Refractive Index Detection), aluminum chloride colorimetric assay, Folin-Ciocalteu and 1,1-Diphenyl-2-picrylhydrazyl (DPPH) were used to determine fructose, glucose, sucrose, maltose; total flavonoids, total phenols and antioxidant activity. Sensorial analysis was realized by using hedonic test and texture profile was performed on a CT 3 Texture Analyzer. The results proved that wheat flour could be successfully replaced by 20% buckwheat and 10% sprouts flours, respectively, improving their nutritional value, without negative influence on texture parameters and sensorial features. The obtained buns were accepted by consumers with a total hedonic score of 9.1 and 8.7, respectively. Hardness, gumminess and adhesiveness were improved by using Magimix improver, meanwhile cohesiveness, springiness, gumminess and adhesiveness were improved by using guar gum.

The effect of sunflower seed flour supplementation on the quality characteristics of wheat flour cracker biscuits was studied. For this purpose, four experimental variants obtained by substituting wheat flour with different proportions (0%, 15%, 25%, and 35%) of sunflower seed flour, were used. The cracker biscuits with sunflower seed flour and the control samples were subjected to physico-chemical and organoleptic analyses. The cracker biscuits, prepared with sunflower seed flour up to a 35% level of supplementation in wheat flour, were found to be acceptable with respect to all sensory attributes. In the present study, significant improvement in the chemical composition (ash, fat, and crude protein) of wheat-flour cracker biscuits supplemented with sunflower seed flour was observed. This reflects the potential for use of sunflower seed flour, as a partial replacement for wheat flour, for enhancement of these nutrients/chemical constituents

The aim of this study was to assess the effect of adding glucose oxidase (GDX) on wheat-maize dough and bread textural characteristics. Ot strengthens the importance and need of replacing wheat flour with maize flour in regions where extensive cultivation of wheat is not possible. For improving the rheological properties of bread, GDX was added to wheat and wheat-maize flours. Wheat and maize flours were used in several ratios, but the best results were obtained for (on flour basis): 80:20, 75:25, 70:30, where the highest values correspond to the wheat flour. Wheat-maize dough and bread volume were slightly influenced by GDX addition. Dough strength was higher in the case of dough without GDX addition than the samples enriched by GDX, while crumb strength of GDX enriched maize bread was higher than the samples without GDX. The obtained data might be useful for future studies, while it was demonstrated here the effect of GDX addition on wheat-maize dough and bread.

Lubricated squeezing flow experiments on wheat flour dough have been performed in constant plate speed and constant extension rate modes. The objective of this work was to assess the effects of the target values on the attained results obtained during wheat dough rheological properties measurement. Different rheometers were used to allow these operations. In both cases, each constant target speed used increases with the increasing time before reaching its stability. These increasing effects versus time are higher with greater speeds. It was obtained 20.1-41.5% of increasing time ratio between the two modes from the lower to higher speeds and for each given speed (0.005-1.5 [mm·s −1 or s −1 ]). The target speed increasing in order to reach the attained value caused sample dough deformation. These strain effects of dough are more important for high initial thickness of dough. Whatever the types of dough strain needed and target speed level used, the limit force measurable in many cases was 40 N (newton). It was a constrain factor for measured values. The data processing to obtain dough rheological properties remains too long and difficult with both measurement methods. PRACTICAL APPLICATIONSIn search of viable ways to study dough rheological properties, the uses of empirical and fundamental methods are of appropriate possibility. Several methods are further able to be used to measure and record dough rheological properties under conditions of unsteady flow. They are used to assess flour ability and provide dough with good breadmaking performance, to mimic dough stretching and to measure its resistance to rupture. Consequently, efficient and versatile methods have opened new possibilities for studying viscoelasticity behaviors related to cereals science and processing. These benefit effects make basic new methods used in breadmaking process, a powerful tool for monitoring the consistency and structural changes in dough and final bread. Because of their major importance in breadmaking process, it is essential in this study to assess the effects of the target values on the attained results in dough rheological properties measurement methods. They can help understand their implications on the data processing of these tests for reliable research on dough rheology. Journal of Texture Studies ISSN 1745-4603

Oat it is known as a cereal which provides numerous health benefits due to its composition. Likewise, hemp, flax and olive oils are rich in compounds required for the wellness maintenance and in prevention and treatment of various diseases. Thanks to advances of last decades in the food industry, it can be said that the rheological measurements have become indispensable in order to obtain a quality product. The aim of this work was to develop and optimize a technology for obtaining unfermented dough, respectively, to obtain oat based unleavened bread. The characterization of the final product from a sensorial point of view was performed, analysis very important for assessing the consumers acceptance. In the meantime the texture properties of all samples were instrumentally determined. Textural profile showed that samples containing higher percent of oil content had a lower hardness than those with reduced percent of oil. The most appreciated unleavened oat bread was dried at 150˚C and had a low content of oil.