This work addresses the durability of structural epoxy adhesives and carbon fibre reinforced polymer (CFRP) laminates typically used in strengthening of existing reinforced concrete structures exposed to natural ageing. The experimental program included four natural (real) outdoor environments inducing ageing mainly caused by carbonation, freeze-thaw attack, elevated temperatures, and airborne chlorides from seawater. Moreover, a control (reference) environment (20 °C of temperature and 55% of relative humidity) and an environment involving water immersion of the materials under controlled temperature (20 °C of temperature) were also included in this investigation. The characterization involved the assessment of the physical, chemical and mechanical properties along a study period of up to two years. Furthermore, comparisons between the natural ageing tests developed in the scope of the present work and accelerated ageing tests existing in the literature were performed. Regarding to the epoxy adhesives, an increase in the glass transition temperature with the time was observed, while the tensile properties decreased, regardless of the outdoor environment. The CFRP laminates were marginally affected by the studied environments. Despite the remarkable dispersion of the results observed in the accelerated ageing tests for the period investigated, this testing protocol yielded higher mechanical degradation than under natural ageing.

No abstract

No abstract

In this study, the possibility to use Horasan mortar as a sliding interface material for pure friction aseismic isolation system is investigated. Both experimental and numerical studies are conducted to examine the effectiveness of using this material in structural isolation systems of buildings with no overturning moment, as it has shown some attractive experiences in time based on the existing related literature. Responses of four storey lightweight building are numerically investigated by finite element modelling in MATLAB; whereas the University Consortium on Instructional Shake Table (UCIST) is used to study the responses of the same building during experimental works. Comparison of both studies is shown to be in a good agreement in terms of resulting structural response accelerations, velocity and displacements. Approximately 28 - 31 % reduction of base floor acceleration is achieved; and the maximum sliding velocity and displacement are found to lie between 0.33-0.45 m/sec and 0.0353-0.0559 m respectively; which fall within the recommended standards’ limits. As a result, these findings demonstrate the effectiveness of using Horasan mortar as friction interface material which has additionally gained experience in more than ten centuries.

Seismic isolation has been widely accepted as one of the techniques that can be used to protect structures during earthquake ground motions. However, some challenges still exist such as the optimal control of excessive isolator shear strains imposed by some ground motions. The main purpose of this study was to assess the effects of building height variation and earthquake ground motion type on the optimal performance of the seismic isolation using lead core rubber bearing (LCRB). Nonlinear time history analysis for building models of various storeys isolated by LCRB and exposed to different real earthquakes was performed. To achieve this, the equations governing the motion of the isolated three different building models were presented, and an approach for solving the equations while taking into consideration of the optimized mechanical properties of the LCRB was developed. The LCRB performance was measured in terms of elastomer shear strains, derived after an optimal criterion leading to reliable substructure and superstructure responses was reached. The results showed that the combined effects of the earthquake type and building height significantly affect the substructure responses (maximum isolator displacement, energy dissipation capacity, maximum isolator force) and the superstructure responses (storey shear forces, storey drifts, floor displacements, and floor accelerations), which in some cases lead to a need for adding a fluid damper. In this regard, an attempt to couple the LCRB with nonlinear fluid viscous damper was made, and the performance of the hybrid was assessed. It was generally found that the hybrid can positively improve the substructure responses, thereby reducing the unwanted large elastomer shear strains without adversely affecting the superstructure responses.