No abstract

No abstract

The aim of this paper is to report a clinical case with bilateral missing mandibular second premolars that were restored by metal-ceramic inlay-retained fixed dental prostheses. The first prosthesis was of a traditional design and the second was of a modified design. The suggested design is created by modifying the retainer wings of the traditional resin-bonded inlay-retained fixed dental prosthesis and covering the wings with composite resin. The modified design is relatively conservative, esthetic and provides an extra element for the retention of posterior metal-ceramic inlay-retained fixed dental prostheses.

This work evaluate the influence of waste pure water sachet (WPS) as a modifier in Hot Mix Asphalt (HMA). The properties of the constituent materials were determined. Modified HMA samples were prepared at varying concentration of 2, 4, 6, 8 and 10% WPS content by weight of the Optimum Binder Content (OBC). The properties of the modified HMA were determined using Marshall Method of mix design. The properties of the constituent materials showed that they are suitable for HMA production. The modified bitumen showed an increase in softening point (61 – 73.5%), flash point (258 – 2820C), fire point (289 – 3110C) and ductility (92.67 –118.67cm) as the WPS content increases from 2% to 10% while decrease in penetration (62.33 – 56.5mm) as WPS content increases from 2% to 6%. Stability and Bulk density increases from 4.64kN to 8.84kN and 2.21g/cm3 to 2.34g/cm3 respectively while flow, voids in mineral aggregates (VMA) and Air voids decreases from 3.6 to 2.98mm, 23.85 to 20.16% and 19.73 to 13.97% respectively as the WPS content was increased from 2 to 8%. An optimum polyethylene from WPS modifier content of 8% by weight of the OBC is  recommended for use in the HMA. Keywords: Bitumen, Hot Mix Asphalt, Pure Water Sachet, modified bitumen, Marshall Properties, Polyethylene.