Effective utilization of the available resources is imperative approach to achieve the apex of productivity.

Leather industry is the second largest export-earning sector of Pakistan. However, because of poor waste management, this industry has been continuously polluting the environment. In this paper, the impact of tanneries on the groundwater quality of Kasur city (i.e., the second largest leather producing city) is examined. The study is conducted in the following three phases: (I) water samples collection, (II) determination of physio-chemical properties, and (III) application of data mining techniques. In phase I, groundwater samples were collected from various sources such as hand pumps, motor pumps, and tube wells. In phase II, several physio-chemical properties such as (i) total dissolved solids (TDS), (ii) pH, (iii) turbidity, (iv) electrical conductivity (EC), (v) total hardness (TH), (vi) total alkalinity (TA), (vii) nitrates, (viii) chromium, (ix) fluoride, and (x) chloride were estimated. The estimated values of all these foregoing parameters are then compared with the Punjab Environmental Quality Standards for Drinking Water (PEQSDW). In phase III, principle component analysis and cluster analysis of the estimated parameters were performed to elucidate the relation between various parameters and to highlight the highly vulnerable sites, respectively. The results exhibit that most of the sampling collections sites are at the threshold of losing quality water. Moreover, it is also found that Mangal Mandi carries the worst groundwater quality among all sampling locations. Overall, it is concluded that serious attention is due from the water and wastewater authorities to further investigate and monitor the groundwater quality of Kasur before the country strikes with another pandemic after COVID-19.

No abstract

Wastewater management is one of the biggest challenges in the world due to increase in population and industrialization. In Faisalabad (FSD), wastewater treatment is being done through Wastewater Stabilization Ponds (WSPs) at Chokera, which is one of the most economical methods of Wastewater Treatment (WWT). Various parameters were examined to check wastewater treatment efficiency of the ponds under diverse climatic conditions. These included Biochemical Oxygen Demand (BOD), pH, Chemical Oxygen Demand (COD), Turbidity, Copper, Total Solids (TS), Total Dissolved Solids (TDS) and Lead. Six locations which were selected for monitoring treatment efficiency, included inlet and outlet of treatment plant, influent of anaerobic ponds, effluent of anaerobic ponds, effluent of facultative ponds, and Pharang drain before and after blending with treated sewage. The testing was performed in two seasons (i.e. Winter 2015 and Summer 2016) in Environmental Engineering Laboratory, Department of Civil Engineering, The University of Lahore, Pakistan. BOD5 removal efficiency of the treatment plant was found 30.08% in winter and 51.74% in summer against designed value of 90% removal. Most of the parameters of the effluent were not meeting the Punjab Environmental Quality Standards (PEQS). The reasons of low efficiency are; variation in climatic conditions (i.e. less solar heat intensity, wind speed and ceased microbial activity in winter), lack of funds by government, increased population, mixing of industrial sewage with domestic sewage and less attention being paid to maintain the performance of Ponds. The study was carried out to assess and compare the efficiency of treatment plant with PEQS in two climatic conditions.

No abstract