The generation of power from solar energy by using Photovoltaic (PV) systems to convert the irradiation of the sun into electricity has been adopted over the past years. However, the PV system’s P–V and I–V characteristics become unstable when solar irradiation and temperature change. In this paper, the incremental conductance (INC) has been improved using signals to measure the current and voltage from the PV systems directly which quickly changes with the environmental conditions, and the conventional particle swarm optimization (PSO) is modified so that under multiple shaded peak PV array curves with fast-changing solar irradiance and temperature, more power is extracted at a faster rate without any tracking failure at high-speed tracking of both individual maximum power point (IMPP) and global maximum power point (GMPP) under varying solar irradiance and temperature at a longer distance to enhance the power generated. The individual and global coefficients are also improved to change with multiple shaded peak PV array curves with fast-changing solar irradiance and temperature. DC-DC converter converts DC power from one circuit to another and DC-AC inverter converts DC power to AC power. Simulation was carried out in MATLAB Simulink with different solar irradiance and temperature whereby the conventional INC and PSO were compared with the proposed INC and PSO. An experiment was carried out for a whole day from 8 am to 5 pm to test the validity of the proposed algorithm and compared it with the conventional INC and PSO by using the solar irradiance and temperature received. From both the simulation and experimental results, the proposed INC and PSO performed better by attaining high power and tracking speed with stable output results than the conventional INC and PSO.

Solar energy is sustained using the principle of photovoltaic effect through a solar photovoltaic (PV) system as the main receiver of sunlight for the island. The use of photovoltaic (PV) systems to generate power from solar energy has increased in recent years due to its availability and sustainability. The proposed bat algorithm provides a very quick confluence and high accuracy since it interactively merges with the exploration advancements with the substantial distinctive signal search during the maximum power point tracking process from the PV array. The improved bat algorithm proposes a signal search method to increase the speed and tracks more power at a longer distance by using the signal between the bat and its prey. An energy storage system (ESS) stores solar energy and releases it into the system for use when energy generation from the source is low. DC to DC converter controls and regulates the output generated voltage from the PV array. DC to AC converter converts DC power produced to AC power to be supplied to the island for use. The design and simulation were performed in MATLAB Simulink and the result shows the effectiveness of the proposed design.

No abstract

A distribution system’s network reconfiguration (NR) is the process of changing the status of the switches to change the topology of the feeders. Using optimal NR at various network load levels, this research proposed an economical way for improving the voltage profile and reducing power loss in distribution systems. A new metaheuristic Heap-based optimizer based on the corporate rank hierarchy is used to solve the optimization problem in order to find the optimal radial distribution network. The objective functions used in this article include voltage profile improvement, power loss reduction, reduction of operation cost, and minimization of gas emissions. This novel technique provides accurate results while avoiding the issue of premature convergence and requires fewer control parameter settings. The proposed method is evaluated at three different load levels on a standard IEEE 33-bus test system, and the simulation results are compared to those of other optimization methods published in the literature, demonstrating that the proposed method improves the system voltage profile while minimizing losses and power costs, establishing that this technique is effective in finding the best result. The Wilcoxon and Friedman tests are also used to verify the effectiveness of the proposed technique.