Molecular electronics has been proposed as a pathway for high-density nanoelectronic devices. This pathway involves the development of a molecular memory device based on reversible switching of a molecule between two conducting states in response to a trigger, such as an applied voltage. Here we demonstrate that voltage-triggered switching is indeed a molecular phenomenon by carrying out studies on the same molecule using three different experimental configurations-scanning tunnelling microscopy, crossed-wire junction, and magnetic-bead junction. We also demonstrate that voltage-triggered switching is distinctly different from stochastic switching, essentially a transient (time-dependent) phenomenon that is independent of the applied voltage.

This article discusses capillary forces measured by scanning force microscopy ͑SFM͒, which, as recently reported, show a discontinuous behavior at a low relative humidity between 20% and 40% depending on the solid surfaces. A capillary force discontinuity is very interesting in terms of a possible phase change or restructuring transition of bulk water in the interfacial solid-liquid region. Unfortunately, we have found that SFM measurements show an inherent weakness in the determination of the origin of the forces that are obtained during pull-off measurements. This article critically discusses the origin of the adhesive interactions as a function of relative humidity with chemically modified probing surfaces. Our measurements indicate that force discontinuities in pull-off measurements are strongly affected by the inability of the liquid to form capillary necks below a critical threshold in relative humidity. In the course of this article, we will discuss roughness effects on capillary forces and provide a modified capillary force equation for asperity nanocontacts.

Different mutants of Cowpea Mosaic Virus (CPMV) have been used as scaffolds to bind 2 and 5 nm gold nanoparticles through gold−sulfur bond formation at specific locations on the virus to produce patterns of specific interparticle distances. TEM images confirm that the bound gold particles produce patterns of gold nanoparticles that correlate well with models built from the known locations of the inserted cysteine groups on the capsid. These results demonstrate that it is possible to use CPMV mutants as nanoscale scaffolds to place gold nanoparticles at fixed interparticle distances.

Reported in this contribution are the synthesis, characterization, and charge transport properties of wire-like Ru2(ap)4(OPEn), where ap is 2-anilinopyridinate and OPE is -(CCC6H4)nSCH2CH2SiMe3 with n = 1 (1) and 2 (2). Scanning tunneling microscopy (STM) measurements of compound 2 inserted into a SAM of C11 thiol reveal that molecule 2 exhibits (i) the stochastic switching characteristic of wire molecules embedded in insulating SAMs and (ii) higher conductivity than the C11 thiol SAM. More importantly, analysis of the molecular electronic decay constant (beta) exhibits a decrease of at least 15% as compared to purely organic molecular analogues. Hence, the transport characteristics of molecules can be significantly improved for nanoscale electronics through the incorporation of a Ru2 fragment into conjugated backbone.