Dental radiology is being extensively used especially after the consolidation of the dental implant technique. Although dental radiology has always been regarded as a low-dose technique, this scenario has changed with the introduction of volumetric techniques and consequent changes that have resulted from the use of the new technique. To compare dose values related to the use of different technologies used in the acquisition of dental panoramic images, the effective dose associated with this image technique was calculated using two different conversion factors for kerma-area product, P(KA), in the effective dose. Twenty-four pieces of equipment were evaluated and distributed into three categories: (1) 19 units of conventional equipment, (2) 3-cone beam computed tomography equipment (CBCT) which has a specific sensor to obtain panoramic images and (3) 2 items of CBCT equipment which only have sensors for volumetric acquisition, and the obtainment of panoramic images is through software reconstruction. The results show values of PKA and effective dose are higher for devices using digital image receptors. It is concluded that optimisation procedures and critical analysis should always be applied when adopting new technologies.

To study the doses received by patient submitted to ionizing radiation, several materials are used to simulate the human tissue and organs. The total mass attenuation coefficient is a reasonable way for evaluating the usage in dosimetry of these materials. The total mass attenuation coefficient is determined by photon energy and constituent elements of the material. Currently, the human phantoms are composed by a unique material that presents characteristics similar to the mean proprieties of the different tissues within the region. Therefore, the phantoms are usually homogeneous and filled with a material similar to soft tissue. We studied ten materials used as soft tissue-simulating. These materials were named: bolus, nylon ® , orange articulation wax, red articulation wax, PMMA, modelling clay, bee wax, paraffin 1, paraffin 2 and pitch. The objective of this study was to verify the best material to simulate the human cerebral tissue. We determined the elementary composition, mass density and, therefore, calculated the total mass attenuation coefficient of each material. The results were compared to the values established by the International Commission on Radiation Units and Measurements -ICRU, report n° 44, and by the International Commission on Radiation Protection -ICRP, report n° 89, to determine the best material for this energy interval. These results indicate that new head phantoms can be constructed with nylon ® .

Tandem systems, each formed by a pencil ionization chamber with and without a specific covering, were developed and tested in standard radiation beams. These systems were designed to be used in computed tomography radiation beams, where the half-value layer (HVL) determination is not an easy task. The behaviour of the tandem systems in diagnostic radiology showed the possibility of their use to confirm HVL values previously determined by the conventional HVL measurement method in quality control programmes. These systems also have other advantages: low cost, easy application and quick measurement procedure.

No abstract

A special parallel-plate ionization chamber was developed. The motivation for the construction of this new chamber was mainly to fulfil the need of a reference system for computed tomography standard beams in the Calibration Laboratory of IPEN. However, the chamber was tested also in standard radiation beams of mammography and conventional diagnostic radiology. The chamber was manufactured at the institute workshop, as simply and cheaply as possible. Its design differs from the common ionization chambers used in dosimetric procedures of computed tomography equipment, because it is a parallel-plate chamber instead of a cylindrical chamber. However, its dimensions and sensitive volume are very similar to those of a commercial pencil ionization chamber. The new ionization chamber was submitted to several characterization and quality control tests, showing its very good performance.