Composite electrochemical coatings (CECs) on the basis of nickel modified with multilayer graphene oxide (GO) were deposited from a sulfate–chloride electrolyte in pulsed electrolysis mode. The microstructure of these CECs was studied by X-ray phase analysis and scanning electron microscopy. It was found that the microhardness of nickel–GO CECs increases by approximately 1.40 times compared to pure nickel. The corrosion–electrochemical behavior of nickel–GO composite coatings in 0.5 M H2SO4 was studied. Based on tests in 3.5% NaCl, it was found that the addition of graphene oxide particles into the matrix of nickel electrodeposits, increases their corrosion resistance by 1.40–1.50 times. This can be explained by the uniformity of the distribution of GO in the nickel matrix, which contributes to the reduction in grain size, as well as the impermeability and stability of graphene oxide.

No abstract

Nickel-based composite electrochemical coatings (CEC) modified with multilayer graphene oxide (GO) were obtained from a sulfate-chloride electrolyte in the reverse electrolysis mode. The microstructure of these CECs was investigated by X-ray phase analysis and scanning electron microscopy. The corrosion-electrochemical behavior of nickel–GO composite coatings in a 0.5 M solution of H2SO4was studied. Tests in a 3.5% NaCl solution showed that the inclusion of GO particles into the composition of electrolytic nickel deposits makes their corrosion rate 1.40–1.50 times less.

No abstract

No abstract