PurposeDecentralized solar systems are increasingly being used as alternative source of off-grid electrification in Bangladesh. They offer solutions to provide (clean) electricity to the low-income households that are not currently served by the national grid. The standards of solar systems need to be improved to maximize the benefits they offer for off-grid electrification.Design/methodology/approachA quantitative research approach was used to explore the power output performance of six solar systems samples. In order to realize a proper load management, daily power production was measured to determine the generation capacity of 50, 60 and 100 Wp monocrystalline and polycrystalline modules when average solar irradiation was 916 W/m2. In the testing system, the irradiation was measured by panel analyzer HT instrument I-V 400. The load arrangement comprised of different kinds of appliances (fan, light, TV). The daily consumption of energy by these loads was calculated using daily operational hours to determine system power performance.FindingsThe authors found that monocrystalline system performs better than polycrystalline by 0.39 kilowatt-hour (kWh) with capacity of 100 watt-peak (Wp) modules. The carbon dioxide (CO2) emissions reduction potential of our sample solar systems were also estimated by assuming a scenario. This was derived by using the electricity emission factor for natural gas (CH4), since CH4 is the main source of energy for power generation in Bangladesh. Savings in CO2 of 0.52 kgCO2/kWh is possible with the adoption of a 100 Wp monocrystalline module.Practical implicationsGovernment actions that promote the use of monocrystalline module will enhance the benefits of the use of solar systems in providing quality and sustainable electricity. This will contribute to government's efforts towards achieving some of the United Nations (UN) sustainable development goals (SDG) and resilience of the most vulnerable population to the effects and impacts of climate change.Originality/valueAlmost all solar modules found in off-grid areas are polycrystalline whose energy generation capacity is much lower compared to monocrystalline types. But use of low efficient polycrystalline solar module hindered the development of country's solar sector and option to save carbon emission. The use of highly efficient monocrystalline solar module will save also the country's land as the country has land scarcity challenges for establishing large-scale solar power plant. The authors also recommend actions that can be implemented at the national level to improve the attractiveness of monocrystalline solar systems in Bangladesh.

The growing need for a secure, cost-effective, less polluting and efficient form of energy has contributed to an increasing interest in the use of micro combined heat and power (MCHP) systems. In this paper, the environmental performance and economic feasibility of a 1 kWe internal combustion engine (ICE) MCHP system in a one-family house was assessed and compared with the baseline scenario were residential energy demands are met with grid electricity and natural gas fired condensing boilers. The result of the analysis shows that MCHP systems present opportunities for savings in energy costs. Based on a social discount rate (SDR) of 5 % and a calculated 3259 operating hours, a simple payback period of about 4.8 years was derived as the time needed to recover the extra investment cost of the ICE unit. The result of the sensitivity analysis reveals that, both the running hours and price of electricity have significant effects on the payback period of the project. Considering the end of useful life period of the systems, MCHP offer a good replacement for conventional gas boilers of 90 % efficiency. However, their high initial costs (when compared to high efficiency condensing boilers), could be seen as the major factor hampering market diffusion. Also, considering the optimal environmental benefits, MCHP system produced more on-site CO2 emissions in reference to the condensing boiler but generally, annual CO2 emission is reduced by about 38 % when compared to the overall separate generation of heat and power scenario.

No abstract