IntroductionNowadays, the renewable energy resource such as solar, wind and biomass has become the most important energy sources due to its environmentally friendly, energy efficiency and reduction of harmful waste. Among energy resource, biomass has been recognized as one of the most utilization resources to provide the platform of chemical in various industries 1−3) . Besides, it has been interesting for many researches due to environmental concern about the emission of greenhouse gas from burning of fossil fuel (coal, oil and gas) and reducing of non-renewable feedstock supply in future. Recently, many researchers have played

The present study aims to investigate the catalytic ethanol dehydration to higher value products including ethylene, diethyl ether (DEE), and acetaldehyde. The catalysts used for this reaction were WO3/TiO2 catalysts having W loading of 13.5 wt.%. For a comparative study, the TiO2 supports employed were varied by two different preparation methods including the sol-gel and solvothermal-derived TiO2 supports, denoted as TiO2-SG and TiO2-SV, respectively. It is obvious that the different preparation methods essentially altered the physicochemical properties of TiO2 supports. It was found that the TiO2-SV exhibited higher surface area and pore volume and larger amounts of acid sites than those of TiO2-SG. As a consequence, different characteristics of support apparently affected the catalytic properties of WO3/TiO2 catalysts. As expected, both catalysts WO3/TiO2-SG and WO3/TiO2-SV exhibited increased ethanol conversion with increasing temperatures from 200 to 400°C. It appeared that the highest ethanol conversion (ca. 88%) at 400°C was achieved by the WO3/TiO2-SV catalysts due to its high acidity. It is worth noting that the presence of WO3 onto TiO2-SV yielded a remarkable increase in DEE selectivity (ca. 68%) at 250°C. In summary, WO3/TiO2-SV catalyst is promising to convert ethanol into ethylene and DEE, having the highest ethylene yield of ca. 77% at 400°C and highest DEE yield of ca. 26% at 250°C. These can be attributed to proper pore structure, acidity, and distribution of WO3.