No abstract

The potential of dilute-acid prehydrolysis as a pretreatment method for sugarcane bagasse, rice hulls, peanut shells, and cassava stalks was investigated. The prehydrolysis was performed at 122 degrees C during 20, 40, or 60 min using 2% H(2)SO(4) at a solid-to-liquid ratio of 1:10. Sugar formation increased with increasing reaction time. Xylose, glucose, arabinose, and galactose were detected in all of the prehydrolysates, whereas mannose was found only in the prehydrolysates of peanut shells and cassava stalks. The hemicelluloses of bagasse were hydrolyzed to a high-extent yielding concentrations of xylose and arabinose of 19.1 and 2.2 g/L, respectively, and a xylan conversion of more than 80%. High-glucose concentrations (26-33.5 g/L) were found in the prehydrolysates of rice hulls, probably because of hydrolysis of starch of grain remains in the hulls. Peanut shells and cassava stalks rendered low amounts of sugars on prehydrolysis, indicating that the conditions were not severe enough to hydrolyze the hemicelluloses in these materials quantitatively. All prehydrolysates were readily fermentable by Saccharomyces cerevisiae. The dilute-acid prehydrolysis resulted in a 2.7- to 3.7-fold increase of the enzymatic convertibility of bagasse, but was not efficient for improving the enzymatic hydrolysis of peanut shells, cassava stalks, or rice hulls.

Alkaline detoxification strongly improves the fermentability of dilute-acid hydrolysates in the production of bioethanol from lignocellulose with Saccharomyces cerevisiae. New experiments were performed with NH4OH and NaOH to define optimal conditions for detoxification and make a comparison with Ca(OH)2 treatment feasible. As too harsh conditions lead to sugar degradation, the detoxification treatments were evaluated through the balanced ethanol yield, which takes both the ethanol production and the loss of fermentable sugars into account. The optimization treatments were performed as factorial experiments with 3-h duration and varying pH and temperature. Optimal conditions were found roughly in an area around pH 9.0/60 degrees C for NH4OH treatment and in a narrow area stretching from pH 9.0/80 degrees C to pH 12.0/30 degrees C for NaOH treatment. By optimizing treatment with NH4OH, NaOH, and Ca(OH)2, it was possible to find conditions that resulted in a fermentability that was equal or better than that of a reference fermentation of a synthetic sugar solution without inhibitors, regardless of the type of alkali used. The considerable difference in the amount of precipitate generated after treatment with different types of alkali appears critical for industrial implementation.

A recombinant Aspergillus niger strain expressing the Hypocrea jecorina endoglucanase Cel7B was grown on spent hydrolysates (stillage) from sugarcane bagasse and spruce wood. The spent hydrolysates served as excellent growth media for the Cel7B-producing strain, A. niger D15[egI], which displayed higher endoglucanase activities in the spent hydrolysates than in standard medium with a comparable monosaccharide content (e.g., 2,100 nkat/ml in spent bagasse hydrolysate compared to 480 nkat/ml in standard glucose-based medium). In addition, A. niger D15[egI] was also able to consume or convert other lignocellulose-derived compounds, such as acetic acid, furan aldehydes, and phenolic compounds, which are recognized as inhibitors of yeast during ethanolic fermentation. The results indicate that enzymes can be produced from the stillage stream as a high-value coproduct in secondgeneration bioethanol plants in a way that also facilitates recirculation of process water.Energy security, petroleum depletion, and global warming have been the main driving forces for the development of renewable fuels that can replace petroleum-derived fuels, such as gasoline and diesel. Bioethanol is currently the most commonly used renewable automobile fuel. It is largely produced by fermentation of sugar-or starch-containing feedstocks, such as cane sugar, corn, and wheat. However, the supply of these crops is relatively limited and many of them can be considered human food resources. Lignocellulose is a more-abundant and less-expensive raw material with the potential to give a high net energy gain (11,17).In the production of bioethanol from lignocellulosic materials, hydrolytic enzymes, such as cellulases and cellobiases, can be used to convert the lignocellulosic polysaccharides to monosaccharides. Microorganisms can be used to ferment the monosaccharides to ethanol. The yeast Saccharomyces cerevisiae is one of the most suitable microorganisms for ethanol production and is favored in industrial processes. However, S. cerevisiae only metabolizes hexose sugars. Many lignocellulosic materials consist of a significant proportion of xylan and arabinan, which give rise to pentose sugars. The cost of enzymes for the hydrolysis of polysaccharides and the inability of S. cerevisiae to utilize pentose sugars have been pointed out as two bottlenecks for commercialization of cellulosic ethanol production (9, 25). Considerable research efforts have therefore been focused on reducing the enzyme cost by producing more-efficient enzymes from cheaper growth media (25). Other efforts have been focused on different approaches to convert pentose sugars to ethanol by using recombinant microorganisms (3, 10).A novel approach to reduce the enzyme cost and to optimally utilize all sugars generated from lignocellulose would be to produce hydrolytic enzymes, such as cellulases, from the pentose fraction remaining after consumption of hexoses by S. cerevisiae (Fig. 1). The cellulases produced can then be used on site in the next round of hydrolysis of the lignoce...

When dilute-acid hydrolysates from spruce are fermented to produce ethanol, detoxification is required to make the hydrolysates fermentable at reasonable rates. Treatment with alkali, usually by overliming, is one of the most efficient approaches. Several nutrients, such as ammonium and phosphate, are added to the hydrolysates prior to fermentation. We investigated the use of NH4OH for simultaneous detoxification and addition of nitrogen source. Treatment with NH4OH compared favorably with Ca(OH)2, Mg(OH)2, Ba(OH)2, and NaOH to improve fermentability using Saccharomyces cerevisiae. Analysis of monosaccharides, furan aldehydes, phenols, and aliphatic acids was performed after the different treatments. The NH4OH treatments, performed at pH 10.0, resulted in a substantial decrease in the concentrations of furfural and hydroxymethylfurfural. Under the conditions studied, NH4OH treatments gave better results than Ca(OH)2 treatments. The addition of an extra nitrogen source in the form of NH4Cl at pH 5.5 did not result in any improvement in fermentability that was comparable to NH4OH treatments at alkaline conditions. The addition of CaCl2 or NH4Cl at pH 5.5 after treatment with NH4OH or Ca(OH)2 resulted in poorer fermentability, and the negative effects were attributed to salt stress. The results strongly suggest that the highly positive effects of NH4OH treatments are owing to chemical conversions rather than stimulation of the yeast cells by ammonium ions during the fermentation.