Nanoporous NiO thin film electrodes were obtained via plasma-assisted microwave sintering and characterized by means of a combination of electrochemical techniques and X-ray photoelectron spectroscopy (XPS). The aim of this study is the elucidation of the nature of the surface changes introduced by the redox processes of this nanostructured material. NiO undergoes two distinct electrochemical processes of oxidation in aqueous electrolyte with the progress of NiO anodic polarization. These findings are consistent with the sequential formation of oxyhydroxide species at the surface, the chemical nature of which was assessed by XPS. Electronic relaxation effects in the Ni 2p spectra clearly indicated that the superficial oxyhydroxide species resulted to be β-NiOOH and γ-NiOOH. We also show for the first time spectral evidence of an electrochemically generated Ni(IV) species. This study has direct relevance for those applications in which NiO electrodes are utilized in aqueous electrolyte, namely catalytic water splitting or electrochromism, and may constitute a starting point for the comprehension of electronic phenomena at the NiO/organic electrolyte interface of cathodic dye-sensitized solar cells (p-DSCs).

The power conversion efficiency (PCE) of NiO based perovskite solar cells recently hit a record 22.1% with hybrid organic-inorganic perovskite composition and a PCE above 15% in the full inorganic...

The electron transfer to self-assembled molecular monolayers carrying a ferrocene (Fc) center, grafted on a flat Si(100) surface, is a recent subject of experimental investigation. We report here the density functional theory (DFT) ab initio calculation of Fc-silicon hybrid redox potentials. The systems were modeled with a slab of H-terminated Si(100) 1 x 1 and 2 x 1 surfaces: geometries were optimized using the ONIOM method, and solute-solvent interactions were included through the polarizable continuum model (PCM) method. Two new routes for Si functionalization with ethyl- (EtFC) and ethynyl-Fc (EFC) differing only in the unsaturation degree of the anchoring arm have been successfully explored, and the redox potential of the resulting hybrids has been measured by cyclic voltammetry: 0.675 and 0.851 V versus NHE for the EtFC and EFC derivatives, respectively. These values, along with the previously measured potential (0.700 V) for the mono-unsaturated derivative, vinyl-Fc, allow the relation between the unsaturation degree and the adduct redox potential to be studied. The comparison among the measured and computed potentials allows one to discriminate between different adduct isomers for the saturated species and more importantly provides strong indications that the carbon-carbon unsaturation initially present in the molecular arm used for anchoring to the surface is preserved upon addition, in contrast with the commonly accepted reaction mechanism.

A reversible electrochemical behavior is demonstrated on a specially prepared redox-functionalized H-Si(100) surface, obtained via an extra-mild grafting procedure from vinylferrocene. The results of a detailed XPS and electrochemical characterization of the resulting hybrid are reported and discussed to propose it as a reference system for high-quality electroactive monolayers on Si. The investigated ferrocene derivative bears a functional group suitable for a mild route to covalent anchoring on Si, which is based on a photoinduced reaction with visible light under an inert atmosphere. Electrochemical reversibility is shown by sharp symmetric voltammograms on freshly prepared p-Si electrodes. Anodic oxide growth is responsible for the progressive degradation of the electrochemical response. Still, fast electron transfer to the surface redox species is maintained during several thousands cycles.