Tunnel valleys are elongated incisions that are commonly interpreted as being the result of erosional processes by subglacial meltwater occurring under continental ice sheets. The abundance, size and the primarily coarse-grained infill of these features have made tunnel valleys important hydrocarbon and groundwater reservoirs. Although numerous tunnel valleys have been described over the last century, their formation and infill remain poorly understood. This review summarizes and discusses the current knowledge of tunnel valleys, providing an overview of the observations around the world. Morphological aspects that separate tunnel valleys from other landforms are discussed, as well as the wide variety of sedimentary environments found to contribute to the infilling of these features. The depth of the incision and the character of ice retreat significantly determine the final infill architecture. The formational hypotheses proposed in the literature are assessed to test their wider applicability to all other tunnel valleys in order to find a generic model that helps in the prediction of the morphology and infilling of both Pleistocene and pre-Pleistocene age. A quasi-steady-state model, with small meltwater outbursts that erode tunnel valleys near the ice margin, seems compatible with most of the known valleys. Other proposed models require specific geographical or climatic conditions

The southern North Sea is a shallow epicontinental sea that was glaciated several times during the Quaternary. The area is known for its remarkable record of tunnel valleys, the age and origin of which are debated. The recent availability of continuous three-dimensional seismic data between the coasts of Britain and the Netherlands provides the opportunity to establish a new seismic interpretation workflow adapted to the intracratonic glaciogenic successions. By analysing the geomorphology of the buried basal glaciogenic unconformity, four distinct major ice fronts are identified and correlated onshore. The ice fronts provide robust relative timelines, and the analysis of tunnel-valley orientations and their merging points indicates that the number of glacial phases has been underestimated. By comparing the erosion capacities of sand and chalk substrates, it is suggested that mechanical abrasion processes are also involved during tunnel-valley genesis. The methods and observations used in this study are applicable to the ancient glaciogenic record in general and constitute a basis for the sedimentological analysis of tunnel valleys

A Quaternary interglacial lake sediment record from the Piànico‐Sèllere Basin (northern Italy) consists of biochemical calcite varves with intercalated detrital layers. At the end of the Piànico Interglacial, continuous varve formation was replaced by predominantly detrital sedimentation. However, 427 varve‐years before this shift, an abrupt increase in the frequency and thickness of detrital layers occurred. Microfacies analyses reveal a total of 152 detrital layers, ranging from 0·2 to 20·15 mm in thickness, deposited during the last 896 years of the Piànico Interglacial. Three microfacies types are distinguished: (i) graded layers, (ii) non‐graded silt layers, and (iii) matrix‐supported layers. The position of detrital layers within an individual varve provides additional information on the season in which they have been deposited. Microfacies analyses in combination with varve counting further enabled precise varve‐to‐varve correlation of the detrital layers for two sediment sections cropping out ca 130 m apart. The detailed intra‐basin correlation allows the source regions of detrital layers to be inferred. Moreover, micro‐erosion at sub‐millimetre scale has been established. Of the described facies types, only the accumulation of summer and spring graded and non‐graded silt layers abruptly increased before the end of interglacial varve formation whereas non‐graded winter silt and matrix‐supported layers are randomly distributed over the entire study period. Heavy rainfalls are assumed to have triggered spring and summer graded layers, so that the occurrence of these layers is thought to be a proxy for extreme precipitation events in the past.

Two Palaeogene fluvial fan systems linked to the south‐Pyrenean margin are recognized in the eastern Ebro Basin: the Cardona–Súria and Solsona–Sanaüja fans. These had radii of 40 and 35 km and were 800 and 600 km2 in area respectively. During the Priabonian to the Middle Rupelian, the fluvial fans built into a hydrologically closed foreland basin, and shallow lacustrine systems persisted in the basin centre. In the studied area, both fans are part of the same upward‐coarsening megasequence (up to 800 m thick), driven by hinterland drainage expansion and foreland propagation of Pyrenean thrusts. Fourteen sedimentary facies have been grouped into seven facies associations corresponding to medial fluvial fan, channelized terminal lobe, non‐channelized terminal lobe, mudflat, deltaic, evaporitic playa‐lake and carbonate‐rich, shallow lacustrine environments. Lateral correlations define two styles of alluvial‐lacustrine transition. During low lake‐level stages, terminal lobes developed, whereas during lake highstands, fluvial‐dominated deltas and interdistributary bays were formed. Terminal lobe deposits are characterized by extensive (100–600 m wide) sheet‐like fine sandstone beds formed by sub‐aqueous, quasi‐steady, hyperpycnal turbidity currents. Sedimentary structures and trace fossils indicate rapid desiccation and sub‐aerial exposure of the lobe deposits. These deposits are arranged in coarsening–fining sequences (metres to tens of metres in thickness) controlled by a combination of tectonics, climatic oscillations and autocyclic sedimentary processes. The presence of anomalously deeply incised distributary channels associated with distal terminal lobe or mudflat deposits indicates rapid lake‐level falls. Deltaic deposits form progradational coarsening‐upward sequences (several metres thick) characterized by channel and friction‐dominated mouth‐bar facies overlying white‐grey offshore lacustrine facies. Deltaic bar deposits are less extensive (50–300 m wide) than the terminal lobes and were also deposited by hyperpycnal currents, although they lack evidence of emergence. Sandy deltaic deposits accumulated locally at the mouths of main feeder distal fan streams and were separated by muddy interdistributary bays; whereas the terminal lobe sheets expand from a series of mid‐fan intersection points and coalesced to form a more continuous sandy fan fringe.