Carbon fiber-reinforced composites represent a broadly utilized class of materials in aeronautical applications, due to their high-performance capability. The studied CFRP is manufactured from a 3K carbon biaxial fabric 0°/90° with high tensile resistance, reinforced with high-performance thermoset molding epoxy vinyl ester resin. The macroscale experimental characterization has constituted the subject of various studies, with the scope of assessing overall structural performance. This study, on the other hand, aims at evaluating the mesoscopic mechanical behavior of a single-ply CFRP, by utilizing tensile test specimens with an average experimental study area of only 3 cm2. The single-ply tensile testing was accomplished using a small scale custom-made uniaxial testing device, powered by a stepper motor, with measurements recorded by two 5-megapixel cameras of the DIC Q400 system, mounted on a Leica M125 digital stereo microscope. The single-ply testing results illustrated the orthotropic nature of the CFRP and turned out to be in close correlation with the multi-ply CFRP tensile and bending tests, resulting in a comprehensive material characterization. The results obtained for the multi-ply tensile and flexural characteristics are adequate in terms of CFRP expectations, having a satisfactory precision. The results have been evaluated using a broad experimental approach, consisting of the Dantec Q400 standard digital image correlation system, facilitating the determination of Poisson’s ratio, correlated with the measurements obtained from the INSTRON 8801 servo hydraulic testing system’s load cell, for a segment of the tensile and flexural characteristics determination. Finite element analyses were realized to reproduce the tensile and flexural test conditions, based on the experimentally determined stress–strain evolution of the material. The FEA results match very well with the experimental results, and thus will constitute the basis for further FEA analyses of aeronautic structures.

Manufacturing aircraft components through 3D printing has become a widespread concept with proven applicability for serial production of certain structural parts. The main objective of the research study is to determine whether a chlorinated polyethylene material reinforced with milled carbon fibers has the potential of replacing the current 5052 NIDA aluminum alloy core of the IAR330 helicopter tail rotor blade, under the form of a honeycomb structure with hexagonal cells. Achieving this purpose implied determining the tensile and compression mechanical properties of the material realized by fused deposition modeling. The tensile tests have been conducted on specimens manufactured on three printing directions, so that the orthotropic nature of the material may be taken into account. The bare compression tests were realized on specimens manufactured from both materials, with similar honeycomb characteristics. All the mechanical tests have been performed on the Instron 8872 servo hydraulic testing system and the results have been evaluated with the Dantec Q400 Digital Image Correlation system. The experimental tests have been reproduced as finite element analyses which have been validated by results comparison, in order to determine if the compression model is viable for more complex numerical analysis.

This paper describes the transition towards a composite structure, with the same overall aerodynamic characteristics, for a tail rotor blade of an IAR330 helicopter. The newly proposed structure of the composite blade is made of a carbon-roving spar embedded with epoxy resin, a hexagonal-cell honeycomb core manufactured by fused deposition modelling, and an outer skin made of multiple carbon-fibre-reinforced laminae. The blade was manufactured by the authors using the hand lay-up method at a scale of 1:3 with respect to the real one, and all stages of the manufacturing process are extensively described in the paper. The experimental tests were performed on an Instron 8872 testing machine by applying a bending force on its free edge, similar to the testing methodology employed by various composite blade manufacturers. A three-dimensional numerical model of the tail rotor blade was conceived, analysed using the finite element method, and validated by comparing the numerical and experimental values of the maximum bending force. Further, the model was used for a complex finite element analysis that showed the very good behaviour of the proposed composite blade during flight and emphasized the main advantages brought by the proposed composite structure.