CT data simulating treating bone as soft tissue as is currently done in MR maps for PET AC leads to a substantial underestimation of tracer uptake in bone lesions and depends on lesion composition, the largest error being seen in sclerotic lesions. Therefore, depiction of cortical bone and other calcified areas in MR AC maps is necessary for accurate quantification of tracer uptake values in PET/MR imaging.

Our results confirmed that an interim PET/CT scan has limited prognostic value in patients with diffuse large B-cell lymphoma homogeneously treated with six cycles of R-CHOP-14 in a large prospective trial. At this point, interim PET/CT scanning is not ready for clinical use to guide treatment decisions in individual patients.

PURPOSE: The aim of this study was to compare detection, lesion conspicuity and reader confidence of F-fluorodeoxyglucose (F-FDG)-PET/MR and F-FDG-PET/computed tomography (CT) in patients with F-FDG avid bone metastases. MATERIALS AND METHODS: In this prospective study, a total of 30 PET/CT and PET/MRI data sets were performed in 24 patients. Each examination was evaluated for the presence of PET-positive bone lesions consistent with metastatic involvement. Conspicuity of PET-positive bone lesions was evaluated on the corresponding PET/CT and PET/MR images and compared using the Wilcoxon signed-ranks test. Reader confidence was determined to evaluate whether PET/CT or PET/MR was more useful for the assessment of the bone metastases and was compared using Student's t-test. RESULTS: Overall, in both examinations, PET/CT and PET/MRI detected 86 F-FDG-positive bone lesions. On all 30 PET/MRI examinations, at least one morphological correlate for F-FDG-positive bone lesions was found on the MR component (82 out of 86 lesions). PET/CT imaging allowed identification of corresponding structural changes on the CT component in 23 out of 30 studies (65 out of 86 lesions). In lesion-by-lesion analysis, the mean lesion conspicuity was significantly better on T1 fat MR imaging compared with CT imaging (P=0.005). In seven out of 30 studies, a significant increase in reader confidence of PET/MRI compared with PET/CT was found. CONCLUSION: PET/MRI offers higher reader confidence and improved conspicuity in bone metastases compared with PET/CT. However, the overall detection rate was not different. The highest possible clinical impact of PET/MRI appears to be in patients with limited, early bone metastatic disease. Materials and methods In this prospective study, a total of 30 PET/CT and PET/MRI data sets were performed in 24 patients. Each examination was evaluated for the presence of PET-positive bone lesions consistent with metastatic involvement. Conspicuity of PET-positive bone lesions was evaluated on the corresponding PET/CT and PET/MR images and compared using the Wilcoxon signed-ranks test. Reader confidence was determined to evaluate whether PET/CT or PET/MR was more useful for the assessment of the bone metastases and was compared using Student's t-test. In lesion-by-lesion analysis, the mean lesion conspicuity was significantly better on T1 fat MR imaging compared with CT imaging (P = 0.005). In seven out of 30 studies, a significant increase in reader confidence of PET/MRI compared with PET/CT was found.Conclusion PET/MRI offers higher reader confidence and improved conspicuity in bone metastases compared with PET/CT. However, the overall detection rate was not different. The highest possible clinical impact of PET/MRI appears to be in patients with limited, early bone metastatic disease. Nucl Med Commun 00:000-000

Modern construction techniques for floor and slab systems often make use of the composite action developed between steel and concrete. Knowledge of the magnitude of adhesive force, other than mechanical bond, is necessary in the design of permanent steel formwork, which ultimately becomes an integral part of the load bearing reinforced concrete structure. To investigate the extent of adhesion at the interface between concrete and flat metal surfaces, different treatments of the metal surfaces were considered. Results are presented for six types of treated and untreated metal plates when tested in a pull-off mode with conventional concrete. The mode and the type of failures were investigated, and those parameters, which are considered to be significant in the study of this phenomenon, evaluated