Energy-harvesting from low-temperature environmental heat via thermoelectric generators (TEG) is a versatile and maintenance-free solution for large-scale waste heat recovery and supplying renewable energy to a growing number of devices in the Internet of Things (IoT) that require an independent wireless power supply. A prerequisite for market competitiveness, however, is the cost-effective and scalable manufacturing of these TEGs. Our approach is to print the devices using printable thermoelectric polymers and composite materials. We present a mass-producible potentially low-cost fully screen printed flexible origami TEG. Through a unique two-step folding technique, we produce a mechanically stable 3D cuboidal device from a 2D layout printed on a thin flexible substrate using thermoelectric inks based on PEDOT nanowires and a TiS2:Hexylamine-complex material. We realize a device architecture with a high thermocouple density of 190 per cm² by using the thin substrate as electrical insulation between the thermoelectric elements resulting in a high-power output of 47.8 µWcm−² from a 30 K temperature difference. The device properties are adjustable via the print layout, specifically, the thermal impedance of the TEGs can be tuned over several orders of magnitudes allowing thermal impedance matching to any given heat source. We demonstrate a wireless energy-harvesting application by powering an autonomous weather sensor comprising a Bluetooth module and a power management system.

Printed thermoelectrics (TE) could significantly reduce the production cost of energy harvesting devices by large-scale manufacturing. However, developing a high-performance printable TE material is a substantial challenge. In this work,...

High-performance Ag−Se-based n-type printed thermoelectric (TE) materials suitable for room-temperature applications have been developed through a new and facile synthesis approach. A high magnitude of the Seebeck coefficient up to 220 μV K −1 and a TE power factor larger than 500 μW m −1 K −2 for an n-type printed film are achieved. A high figure-of-merit ZT ∼0.6 for a printed material has been found in the film with a low in-plane thermal conductivity κ F of ∼0.30 W m −1 K −1 . Using this material for n-type legs, a flexible folded TE generator (flexTEG) of 13 thermocouples has been fabricated. The open-circuit voltage of the flexTEG for temperature differences of ΔT = 30 and 110 K is found to be 71.1 and 181.4 mV, respectively. Consequently, very high maximum output power densities p max of 6.6 and 321 μW cm −2 are estimated for the temperature difference of ΔT = 30 K and ΔT = 110 K, respectively. The flexTEG has been demonstrated by wearing it on the lower wrist, which resulted in an output voltage of ∼72.2 mV for ΔT ≈ 30 K. Our results pave the way for widespread use in wearable devices.

Additive manufacturing (AM) is a recent growing technology, which is currently implemented for different application fields, from rapid prototyping to cost-effective manufacturing of industrial components with complex shapes. Printable thermoelectric materials offer synergies with AM and can be integrated into 3D printed thermoelectric generators (TEGs). In this work, we have formulated an Ag 2 Se-based n-type printable thermoelectric (TE) ink with a high figure-of-merit of ∼1 at room temperature. Three scaffolds with different shapes have been printed using 3D printing. The developed ink as ntype legs and commercially available PEDOT as p-type legs were then painted on the 3D printed scaffolds to fabricate three TEGs with a different number of legs and shapes. The performance of the TEGs was studied for different temperature differences between ΔT = 10 and 70 K. Power output (P max ) levels of several microwatts and output voltages of several millivolts can be easily achieved.