OECD ready biodegradability tests have been central to understanding the biodegradation of chemicals from a regulatory perspective for many decades. They are not fit for contemporary prioritisation of chemicals based on persistence, however, due to the low concentration of inocula used, short duration and high variability between tests. Two OECD standard inoculum pretreatment methods (settlement and filtration) were investigated to observe their effect on the probability of biodegradation and associated changes in bacterial community structure and diversity of inocula sourced from the activated sludge process of wastewater treatment plants. Both settlement and filtration were shown to dramatically and significantly reduce the probability and increase the variability of biodegradation of 4-nitrophenol compared to the use of unprocessed inocula. These differences were associated with a significant hundred-fold reduction in cell numbers and solids content and a significant shift in bacterial community structure that was sometimes accompanied by significant reductions in detectable operational taxonomic unit richness and evenness. The natural variation (between different environments) and variation due to differential selection of bacterial communities (by different pretreatment methods) is offered as an explanation for the historical high variability in standard OECD ready biodegradability tests.Electronic supplementary materialThe online version of this article (doi:10.1007/s11356-013-2064-4) contains supplementary material, which is available to authorized users.

Concentrating cells from aqueous samples is a common requirement for the enumeration of biomass, investigations of microbial diversity and detection of relatively rare organisms in the environment. Accurately representing the initial sampled environments in the concentrated cells is of particular importance when the subsequent analyses have tangible environmental, economic and societal consequences, as is the case with environmental exposure and risk assessment of chemicals. This study investigated the potential use of four different cell concentration methods: centrifugation, membrane filtration, tangential flow filtration and column colonisation. These methods were assessed against a series of scientific and practical criteria, including: similarity of concentrated community to initial environmental sample; cell concentration achieved; biodegradation test outcome; sample throughput; and capital and maintenance costs. All methods increased cell concentration by as little as 10-fold to as much as 1000-fold. DGGE and 454 pyrosequencing analysis showed concentrated communities to have >60% similarity to each other, and the initial sample. There was a general trend for a more reliable assessment of 4-nitrophenol biodegradation in 96-well plate biodegradation assays, with increasing cell concentration. Based on the selection criteria, it is recommended that there is not one concentration method fit for all purposes, rather, the appropriate method should be selected on a case-by-case basis. Membrane filtration would be the most suitable method for low sample volumes; the increased throughput capacity of tangential flow filtration renders it most suitable for large volumes; and centrifugation is most suitable for samples with high initial biomass concentrations. The poor similarity in microbial community composition of the column colonised samples compared to the initial samples, suggested a concentration basis; this combined with its low sample throughput precluded this approach for future concentration studies of planktonic bacterial samples.

Comprehensive assessment of environmental biodegradability of pollutants is limited by the use of low throughput systems. These are epitomized by the Organisation for Economic Cooperation and Development (OECD) Ready Biodegradability Tests (RBTs), where one sample from an environment may be used to assess a chemical's ability to readily biodegrade or persist universally in that environment. This neglects the considerable spatial and temporal microbial variation inherent in any environment. Inaccurate designations of biodegradability or persistence can occur as a result. RBTs are central in assessing the biodegradation fate of chemicals and inferring exposure concentrations in environmental risk assessments. We developed a colorimetric assay for the reliable quantification of suitable aromatic compounds in a high throughput biodegradation screening test (HT-BST). The HT-BST accurately differentiated and prioritized a range of structurally diverse aromatic compounds on the basis of their assigned relative biodegradabilities and quantitative structure-activity relationship (QSAR) model outputs. Approximately 20 000 individual biodegradation tests were performed, returning analogous results to conventional RBTs. The effect of substituent group structure and position on biodegradation potential demonstrated a significant correlation (P < 0.05) with Hammett's constant for substituents on position 3 of the phenol ring. The HT-BST may facilitate the rapid screening of 100 000 chemicals reportedly manufactured in Europe and reduce the need for higher-tier fate and effects tests.

No abstract