Objective-Surface roughness and surface free energy are two important factors that regulate cell responses to biomaterials. Previous studies established that titanium substrates with micron-scale and submicron scale topographies promote osteoblast differentiation and osteogenic local factor production and that there is a synergistic response to microrough Ti surfaces that have retained their high surface energy via processing that limits hydrocarbon contamination. This study tested the hypothesis that the synergistic response of osteoblasts to these modified surfaces depends on both surface microstructure and surface energy.Methods-Ti disks were manufactured to present three different surface structures: smooth pretreatment surfaces (PT) with R a of 0.2 µm; acid-etched surfaces (A) with a submicron roughness R a of 0.83 µm; and sandblasted/acid-etched surfaces (SLA) with R a of 3-4 µm. Modified acid-etched (modA) and modified sandblasted/acid-etched (modSLA) titanium substrates, which have low contamination and present a hydroxylated/hydrated surface layer to retain high surface energy, were compared with regular low surface energy A and SLA surfaces. Human osteoblast-like MG63 cells were cultured on these substrates and their responses, including cell shape, growth, differentiation (alkaline phosphatase, osteocalcin), and local factor production (TGF-β1, PGE 2 , osteoprotegerin [OPG]) were analyzed (N=6 per variable). Data were normalized to cell number.Results-There were no significant differences between smooth PT and A surfaces except for a small increase in OPG. Compared to A surfaces, MG63 cells produced 30% more osteocalcin on modA, and 70% more on SLA. However, growth on modSLA increased osteocalcin by more than 250%, which exceeded the sum of independent effects of surface energy and topography. Similar effects were noted when levels of latent TGF-β1, PGE 2 and OPG were measured in the conditioned media.Conclusions-The results demonstrate a synergistic effect between high surface energy and topography of Ti substrates and show that both micron scale and submicron scale structural features are necessary.

Rough titanium (Ti) surface microarchitecture and high surface energy have been shown to increase osteoblast differentiation, and this response occurs through signaling via the α2β1 integrin. However, clinical success of implanted materials is dependent not only upon osseointegration but also on neovascularization in the peri-implant bone. Here we tested the hypothesis that Ti surface microtopography and energy interact via α2β1 signaling to regulate the expression of angiogenic growth factors. Primary human osteoblasts (HOB), MG63 cells and MG63 cells silenced for α2 integrin were cultured on Ti disks with different surface microtopographies and energies. Secreted levels of vascular endothelial growth factor-A (VEGF-A), basic fibroblast growth factor (FGF-2), epidermal growth factor (EGF), and angiopoietin-1 (Ang-1) were measured. VEGF-A increased 170% and 250% in MG63 cultures, and 178% and 435% in HOB cultures on SLA and modSLA substrates, respectively. In MG63 cultures, FGF-2 levels increased 20 and 40-fold while EGF increased 4 and 6-fold on SLA and modSLA surfaces. These factors were undetectable in HOB cultures. Ang-1 levels were unchanged on all surfaces. Media from modSLA MG63 cultures induced more rapid differentiation of endothelial cells and this effect was inhibited by anti-VEGF-A antibodies. Treatment of MG63 cells with 1α,25(OH)2D3 enhanced levels of VEGF-A on SLA and modSLA. Silencing the α2 integrin subunit increased VEGF-A levels and decreased FGF-2 levels. These results show that Ti surface microtopography and energy modulate secretion of angiogenic growth factors by osteoblasts and that this regulation is mediated at least partially via α2β1 integrin signaling.

The surface properties of materials contribute to host cellular response and play a significant role in determining the overall success or failure of an implanted biomaterial. Rough titanium (Ti) surface microtopography and high surface free energy have been shown to enhance osteoblast maturation in vitro and increase bone formation in vivo. While the surface properties of Ti are known to affect osteoblast response, host bone quality also plays a significant role in determining successful osseointegration. One factor affecting host bone quality is patient age. We examined both in vitro and in vivo whether response to Ti surface features was affected by animal age. Calvarial osteoblasts isolated from 1-, 3-, and 11-month-old rats all displayed a reduction in cell number and increases in alkaline phosphatase specific activity and osteocalcin in response to increasing Ti surface microtopography and surface energy. Further, osteoblasts from the three ages examined displayed increased production of osteocalcin and local factors osteoprotegerin, VEGF-A, and active TGF-β1 in response to increasing Ti surface roughness and surface energy. Latent TGF-β1 only increased in cultures of osteoblasts from 1- and 3-month-old rats. Treatment with the systemic osteotropic hormone 1α,25(OH)2D3 further enhanced the response of osteoblasts to Ti surface features for all three age groups. However, osteoblasts derived from 11-month-old animals had a reduced response to 1α,25(OH)2D3 as compared to osteoblasts derived from 1-or 3-month-old animals. These results were confirmed in vivo. Ti implants placed in the femoral intramedullary canal of old (9-month) mice yielded lower bone-to-implant contract and neovascularization in response to Ti surface roughness and energy compared to younger (2-month) mice. These results show that rodent osteoblast maturation in vitro as well as new bone formation in vivo is reduced with age. Whether comparable age differences exist in humans needs to be determined.

Osteoarthritis (OA) is a progressive degenerative joint disease, and to date, no disease-modifying OA drug exists. Amniotic membrane and umbilical cord products have been used clinically in several diseases due to their anti-inflammatory and antiscarring properties. In the present study, we sought to evaluate whether a particulate amniotic membrane and umbilical cord (AM/UC) matrix could aid in attenuating disease progression. Lewis rats underwent medial meniscus transection (MMT) to induce OA. Two weeks after surgery, animals received intra-articular injections (50 μL) of either 50 or 100 μg/μL particulate AM/UC or saline control and were subsequently euthanized 1 or 4 weeks later. Cartilage degeneration was assessed using both histological scoring methods and equilibrium partitioning of an ionic contrast agent-microcomputed tomography (EPIC-μCT). EPIC-μCT analysis demonstrated that overall cartilage destruction was attenuated, with a significant increase in both cartilage thickness and volume as well as a significant decrease in total lesion area in animals injected with either dose of particulate AM/UC at 1 week, but only a high dose at 4 weeks postinjection. Osteoarthritis Research Society International (OARSI) histology scores of tibial sections corroborated EPIC-μCT results. Overall joint destruction was attenuated in animals injected with either dose of AM/UC tissue compared with saline-injected control animals at 1 week postinjection. Only high-dose AM/UC-injected animals continued to show less overall joint destruction by 4 weeks postinjection. Intra-articular injection of particulate AM/UC tissue attenuates cartilage degradation in a rat MMT model of OA, suggesting that it may be able to slow joint destruction in patients with OA.