A membrane with interpenetrating networks between poly͑vinyl alcohol͒ ͑PVA͒ and poly͑styrene sulfonic acid͒ ͑PSSA͒ coupled with a high proton conductivity is realized and evaluated as a proton exchange membrane electrolyte for a direct methanol fuel cell ͑DMFC͒. Its reduced methanol permeability and improved performance in DMFCs suggest the new blend as an alternative membrane to Nafion membranes. The membrane has been characterized by powder X-ray diffraction, scanning electron microscopy, time-modulated differential scanning calorimetry, and thermogravimetric analysis in conjunction with its mechanical strength. The maximum proton conductivity of 3.3 ϫ 10 −2 S/cm for the PVA-PSSA blend membrane is observed at 373 K. From nuclear magnetic resonance imaging and volume localized spectroscopy experiments, the PVA-PSSA membrane has been found to exhibit a promising methanol impermeability, in DMFCs. On evaluating its utility in a DMFC, it has been found that a peak power density of 90 mW/cm 2 at a load current density of 320 mA/cm 2 is achieved with the PVA-PSSA membrane compared to a peak power density of 75 mW/cm 2 at a load current density of 250 mA/cm 2 achievable for a DMFC employing Nafion membrane electrolyte while operating under identical conditions; this is attributed primarily to the methanol crossover mitigating property of the PVA-PSSA membrane. Direct methanol fuel cells ͑DMFCs͒ using a proton exchange membrane have been identified as one of the most promising candidates for portable power applications.1,2 Unlike hydrogen-air polymer electrolyte fuel cells, DMFCs do not require a fuel reformer or a high-volume hydrogen storage system. The membrane electrolyte employed with the DMFC, besides exhibiting a good proton conductivity, should act as a physical separator to prevent fuel crossover from the anode to the cathode. At present, Nafion a perfluorosulfonated membrane with a hydrophobic fluorocarbon backbone and hydrophilic sulfonic acid pendant side chains, happens to be the only commercially available and widely used membrane electrolyte in the DMFC. It has been documented that proton conduction in Nafion occurs through the ionic channels formed by micro-or nanophase separation between the hydrophilic proton exchange sites and the hydrophobic domains.3 However, the methanol crossover from anode to cathode across the Nafion membrane brings about a mixed potential at the cathode causing both the loss of fuel and cell polarization impeding their commercial realization. [4][5][6] It has been reported that even over 40% of methanol could be lost in a DMFC due to crossover across the membrane.7 Methanol crossover across the Nafion membrane can be kept to a minimum by controlling the methanol-feed concentration. Alternatively, membranes that are relatively impermeable to methanol have been employed for this purpose. [8][9][10][11][12] Membranes with a lower methanol permeability allow a higher methanol-feed concentration, enhancing the performance of the DMFC. To optimize fuel cell performance, it is neces...

No abstract

No abstract

The dynamic behavior of continuous wave (cw) laser-induced crystallization in the a-Si:H film on a quartz substrate is studied by light scattering. Microcrystals of dimensions less than 30 Å could be grown in a stable state and it is demonstrated that the surface-to-volume correction is essential for estimating the frequency of the crystallinelike mode. It is suggested that bulk-induced crystallization may be responsible for the formation of very small crystallites.