By modifying the walls of a glass microchannel so that one side is hydrophilic and the other hydrophobic, countercurrent laminar flow of an organic phase relative to an aqueous phase is effected (see picture). This system is applied to the efficient extraction of a cobalt complex from toluene into water.

Parallel multiphase microflows, which can integrate unit operations in a microchip under continuous flow conditions, are discussed. Fundamental physics, stabilization methods and some applications are shown.

This paper reports a new technique of micro-resolution particle image velocimetry (PIV). To investigate transient phenomena in a microfluidic device, a high-speed micro-PIV technique was developed by combining a high-speed camera and a continuous wave (CW) laser. The technique was applied to a micro counter-current flow, consisting of water and butyl acetate. The velocity fields of water in the micro counter-current flow were visualized for a time resolution of 500 µs and a spatial resolution of 2.2 × 2.2 µm 2 . Using the micro-PIV technique, the vortex-like motions of fluorescent particles around the water-butyl acetate interface were captured clearly.

An interfacial pressure balance model was proposed and verified for the elucidation of the physical mechanism of micro countercurrent flow in a hydrophilic-hydrophobic selective-modification microchannel. We considered the conditions of the microflow phase separation, where the phase separation entails a single phase flow in each output of the microchannel. In this pressure balance model, the pressure difference between the two phases due to pressure loss in each phase is balanced by the Laplace pressure generated by the interfacial tension at the liquid-liquid interface between the separated phases. When the pressure difference between the two phases is sufficiently low, the contact line between the two phases is pinned at the boundary between the hydrophilic and the hydrophobic surfaces. Since the contact angle is restricted to values between the advancing and receding contact angles, the Laplace pressure has a limit. When the pressure difference between the two phases exceeds the limiting Laplace pressure, one of the phases leaks into the output channel of the other phase, and the phase separation fails. In order to experimentally verify this physical picture, a microchip with an asymmetric cross section, whose hydraulic diameters were 19 and 102 mum, was used. In the microchip, a phase separation of a water-toluene micro countercurrent flow was achieved under pressure differences between an upper limit of 6.9 kPa and a lower limit of -9.3 kPa. The upper limit agreed well with the proposed model. The model is also applicable to cocurrent flows, so that it is useful for general multiphase microflows in continuous-flow chemical processing.