No abstract

DOI to the publisher's website. • The final author version and the galley proof are versions of the publication after peer review. • The final published version features the final layout of the paper including the volume, issue and page numbers. Link to publication General rights Copyright and moral rights for the publications made accessible in the public portal are retained by the authors and/or other copyright owners and it is a condition of accessing publications that users recognise and abide by the legal requirements associated with these rights. • Users may download and print one copy of any publication from the public portal for the purpose of private study or research. • You may not further distribute the material or use it for any profit-making activity or commercial gain • You may freely distribute the URL identifying the publication in the public portal. If the publication is distributed under the terms of Article 25fa of the Dutch Copyright Act, indicated by the "Taverne" license above, please follow below link for the End User Agreement:

Transient voltages from (dis)connecting compensation coils near high voltage transformers are studied. Non-invasive sensors are needed in order to exclude any influence by the measurement equipment on the overvoltage magnitude. This study describes results from open-air capacitive sensors as part of a differentiating/integrating measurement system. Its bandwidth (up to 10 MHz) allows to record large detail in the switching events. However, the coupling strengths and the cross-couplings inherent to the use of air capacitive sensors need to be determined. Calibration based on symmetric phase voltages during normal operation supplies part of the information. Three methods are compared to supplement this knowledge for establishing the complete coupling matrix between phase conductors and sensors. One method employs estimates from the system configuration, in particular, its symmetry. The other techniques extract information from fast transient events within the responses for both switching on and off. The decoupled waveforms from different methodologies align within their confidence bounds and predict the maximum overvoltage magnitudes within an accuracy of 5% when employing information from the fast transients. Based on measurements performed on two compensation coils, both tested three times, larger overvoltages occurred during energisation compared to de-energisation with maximum amplitude exceeding three per unit. (a) The sensor signals, waveforms after decoupling based on (b) Symmetry, (c) Energisation, (d) De-energisation. The arrows indicate instances where the crosscoupled oscillation from phases 1 and 3 start dominating the (faster) oscillation in the signal representing the interrupted phase 2 IET Sci. Meas. Technol.

No abstract

No abstract